Configuration - Black & Decker FSMH1321 Traduction De La Notice D'instructions Originale

Configuration

F B B B
S H H H
M S S S
H M M M
1 1 1 1
3 6 6 6
2 8 8 6
1 D U D
S
M
12

12a
  
12d
  
13
   
16
   
18
   
18a
19
   
20
 
20a
 
21
 
21a
22
22a
22b
22c
23
  
24

25

26

27
28
29
Assembly
@
Warning! Before attempting any of the following
instructions, make sure that the appliance is
switched off and unplugged and the appliance is
cold and does not contain any water.
Attaching the handle (Fig. A)
Slide the bottom end of the handle (8) into the top end of
u
the steam mop body (11) until it clicks into place.
Attachin
g the hand held steam cleaner (Fig. B)
Holding the back of the steam mop body (11) push the
u
hand held steam cleaner (5) firmly into the steam mop
body (11) making sure it sits correctly over the interface
(11a) and clicks securely into place.
B B B B B
H H H H H
S S S S S
M M M M M
1 1 1 1 1
6 6 6 6 6
8 9 1 1 1
D D 0 5 5
S S D D D
M M S S S
M M G
     
     
     
     
   
 
   
 
 
   
   
  
  
  
  
     
     
     
     
  
  
 
(Original instructions)
Removing
Push the release button (10) on the main body (11) and lift
u
B S
H E
the hand held steam cleaner (5) off the interface (11a) and
S T
M T
away from the main body (11).
1 I
6 N
1 G
5 S
Attaching a cleaning pad (Fig. C)
D
A
Replacement cleaning pads are available from your
M
BLACK+DECKER dealer :- (cat no. FSMP20-XJ).
All
Place a cleaning pad (13) on the floor with the velcro 'loop'
u
All
side facing up.
All
Lightly press the steam mop down onto the cleaning pad
u
(13).
All
Note: This unit may be supplied with a standard floor cleaning
All
head (12) or a steam burst cleaning head (12a). In either case
●
use these instructions to fit a cleaning pad.
● ● ●
Caution! Never leave the steam mop in one spot on any
● ● ●
surface for any period of time. Always place the steam mop
● with the handle (8) supported in the upright position when
stationary and make sure the steam mop is turned off when
●
not in use.
●
●
Removing a cleaning pad
All
Caution! Always wear suitable shoes when changing the
All
cleaning pad on your steam mop.
All
Do not wear slippers or open toed footwear.
Return the handle (8) to the upright position and turn the
All
u
steam mop 'OFF'.
All
Wait until the steam mop cools down (approximately 5
All
u
minutes).
All
Lift the steam mop away from the cleaning pad freeing it
u
All
from the velcro fastening.
All
Caution! Never leave the steam mop in one spot on any
surface for any period of time.
All
Always place the steam mop with the handle (8) supported in
All
the upright position when stationary and make sure the steam
mop is turned off when not in use.
Filling the water tank (Fig. O)
Note! Fill the water tank with clean tap water (Do not use any
additives or chemicals).
Note! In areas of hard water, the use of de-ionised water is
recommended.
Open the filler cap (4) by flipping it up.
u
Fill the water tank with water (Do not use any additives or
u
chemicals).
Warning! When filling, detach from main unit and maintain in
a horizontal position.
Warning! Your water tank has a 0.5 litre capacity. Do not over
fill the tank.
Close the filler cap (4).
u
Note! Ensure the filler cap is firmly secured.
the hand held steam cleaner (Fig. B)
ENGLISH
11