Christopeit Sport WP1000 Notice De Montage Et D'utilisation page 12

Assembly Instructions
Remove all the separate parts from the packaging, lay them
on the floor and check roughly that all are there on the base of
the assembly steps.
Please note that a number of parts are connected directly to
the main frame preassembled. In addition, there are several
other individual parts that have been attached to separate
units. This will makes assembly easier and quicker for you.
Assembly time: 15 min.
Step 1:
Attach the rear foot (75) at slide rail (69).
1. Put the rear foot (75) under the seat rail (69) and screw it tight-
ly by using screw M8x16 (77), washers 8//19 (51) and spring
washers for M8 (78).
Step 2:
Attach the seat rail (69) at frame (52).
1. Put the seat rail (69) onto the holder at
frame (52) sothat the side
holes are align and tighten the side
rail (69) at frame (52) by using screw
M10x125 (65), washer 10//20 (66) and
nylon nut M10 (67). Don't tighten the
screw (65) too much, sothat the fold up
system works easy.
2. Secure the seat rail (69) before training
by screw in the hand grip screw (68),
Washer (91) and lock up with locking pin
(70).
Step 3:
Attach the computer (1) at computer support (2).
1. Take the computer (1) and insert the batteries (Type
"AA"-1.5V pencells) by watching for the right pola-
rity on the back of the computer (1). (Batteries for
the computer are not included in this item. Please
buy them at your located market.)
2. Lead the computer (1) to computer holder (2) and
push the plug of the sensor cables (3) into the as-
sociated socket of the computer (1).
3. Storage the cable connection and put the compu-
ter (1) on the computer holder (2) until it clicks into
place.
12