Threading The Upper Looper - Janome 3434D Livret D'instructions

9
(A)
1
2
3
3
36
1
2
3
4
5
8
6
7
1
(B)
2
•

Threading the Upper Looper

Place a spool of thread on the spool pin second from
the right.
* The points to thread for upper looper are marked
in red.
* A convenient threading chart is placed on the
machine body inside the looper cover.
1. Draw the thread through the thread guide second
from the right from back to front.
* If the thread is coming out from the thread guide
groove, pass the thread through the thread guide
hole again as shown.
1 Thread guide
2. Pass the thread through the holes in the second
row from the right of thread guide plate as
illustrated.
2
Thread guide plate
3. Pass the thread through the left side of looper
thread guide sliding the thread from right to left.
3
Looper thread guide