Threading The Lower Looper - Janome 3434D Livret D'instructions

Table des Matières

Publicité

11
10
9
1
(A)
1
2
3
3
30
2
3
5
4
6
7
8
(B)
2

Threading the Lower Looper

Open the looper cover and side cover.
1
Place the spool of thread on the right side spool pin.
* The points to thread for lower looper are marked
in green.
* A convenient threading chart is placed on the
machine body inside the looper cover.
1. Draw the thread through the right side thread
guide from back to front.
* If the thread is coming out from the thread guide
groove, pass the thread through the thread guide
hole again as shown.
1
Thread guide
2. Pass the thread through the holes on the right
side of the thread guide plate as illustrated.
2
Thread guide plate
3. Pass the thread through the right side of the
looper thread guide, sliding the thread from left to
right.
3
Looper thread guide

Publicité

Table des Matières
loading

Table des Matières