Threading The Looper - Janome CoverPro 1000CPX Manuel D'utilisation

Janome CoverPro 1000CPX Instruction Manual
8
q
z
(B)
x
w
www.janomeflyer.com
2
3
7
4
5
6
(A)

Threading the looper

1
Thread the looper in the following steps:
z Draw the thread through the right side thread guide
bar from back to front as shown (A).
NOTE:
If the thread is coming out from the thread guide notch,
pass the thread through the thread guide hole again as
shown (B).
q Thread guide bar
x Pass the thread through the holes on the right side
of the thread guide plate as illustrated.
w Thread guide plate
24
1000CPX Owners Manual/ User Guide