Delta SOLIVIA 15 EU G3 TL Manuel D'utilisation Et D'installation page 26

CAUTION
Note: Make sure the line is provided with a strain relief device. When using cables with a diameter
of less than 13mm (11 mm - 13 mm diameter cable require strain relief), the cable must be relieved
just behind the connector.
The connection to the Amphenol AC connector can be made with a flexible or rigid cable and a con-
ductor cross section of 4.0 mm
wires (for other applications please contact Amphenol).
Please note the cable length and the cable cross-section, due to the risk of undesirable temperature
rise and power losses. In some countries (e.g. France, Germany) system installation requirements
have to be followed (UTE 15712-1, VDE 0100 712). This recommendation will define minimum
cable sections and protections against overheating due to high currents. Please make sure that you
follow specific requirements in your country.
For the security of your installation and for the safety of the user, please install required safety
and protection devices that are applicable for your installation environment (example: automatic
circuit breaker and/or overcurrent protection equipment). As the integrated RCD is compliant with
VDE V 0126-1-1 and according to VDE 0100-712 (§712,413,1,1,1,2, the RCD can be considered as
a type B protection device (for Germany only).
WARNING!
The solar inverter must be grounded via the AC connector's PE conductor. To do this, connect the
PE conductor to the designated terminal.
The AC connector is protected from unintentional disconnection by a clip mechanism which can be
released with a screwdriver.
24
Observe the pin assignment of the AC bayonet connector. An in-
correct assignment can result in the unit being destroyed. The
figure 5-3 pin out diagram shows the connections inside the AC
connector.
or 6.0 mm . This connector is developed for connection to copper
2 2
In the case of damage or bodily harm resulting from the use of
this device in a way contrary to it's intended purpose or as a result
of unauthorized modifications made to the parameters of the in-
verter, Delta will not be held liable in these situations.