Front Installation For Rack Mounting; Rear Installation For Rack Mounting; Instructions - Eaton ATS 30 Manuel D'installation Et D'utilisation

3. Installation for ATS
3.3

Front installation for rack mounting

Follow steps 1 to 3 for module mounting on the rails.
3.4

Rear installation for rack mounting

Follow steps 1 to 3 for module mounting on the rails.
3.5

Instructions

1. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient. Therefore, consideration
should be given to installing the equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
2. Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
3. Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical loading.
4. Circuit Overloading - Consideration should be given to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this
concern.
5. Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular
attention should be given to supply connections other than direct connections to the branch circuit (e.g.
use of power strips).
Page 6
ATS-01_EN