Eaton ATS 30 Manuel D'installation Et D'utilisation page 66

8. SNMP IPv6 for ATS
8.6 ATS Command Settings
Command Description
Log Report the event code and time of prior
transfers.
Tprev[1..9] Report the time of prior transfer/event.
Tprev1 is the most recent time.
Event[1..9] Report the event code for prior transfer.
Event1 is the most recent event.
ClearLog Clear event log.
SetTime Set the present time.
SetDate Set the present date.
SetPrefer Set the preferred source.
SetDevID Set the unit device ID.
SetVtp2s Set the primary to secondary trip voltage.
SetVts2p Set the secondary to primary trip voltage.
SetVbp2s Set the primary to secondary brownout
voltage.
SetVbs2p Set the secondary to primary brownout
voltage.
SetTdp2s Set the recover time of transfer from primary
to secondary.
SetTds2p Set the recover time of transfer from
secondary to primary.
SetMvs1 Set the max voltage of comparing cycles for
primary AC blackout.
SetMvs2 Set the max voltage of comparing cycles for
secondary AC blackout.
SetMts1 Set the max time of comparing cycles for
primary AC blackout.
SetMts2 Set the max time of comparing cycles for
secondary AC blackout.
Page 6
Parameter Response
1 ~ 10 hh:mm:ss MM/DD/YYYY
hh:mm:ss MM/DD/YYYY
hh:mm:ss
[MM/DD/YYYY]
MM/DD/YYYY
1 or 2
<20 characters>
alphanumeric
only
165.0 ~ 175.0
165.0 ~ 175.0
180.0 ~ 264.0
180.0 ~ 264.0
12.0 ~ 1800.0
12.0 ~ 1800.0
30 ~ 50
30 ~ 50
2.0 ~ 4.0
2.0 ~ 4.0
0x#
0x#
IPv6 for ATS-00_EN