Communication Card - Eaton ATS 30 Manuel D'installation Et D'utilisation

5. Operation
5.2

Communication card

N° Indicator
NETWORK port
1
LOCAL port
2
RESET button
3
LED indicators
4
DIP switch
5
LED indicators
LED
NET LED
NET LED
ATS LED
ATS LED
ATS LED
DIP switch
DIP 1
OFF
OFF
ON
ON
Page 10
Description
Connects to the Ethernet Network
Connects to a workstation with an RJ45 to DB9 cable to configure the
system.
Resets InsightPower SNMP IPv6 for ATS (hereafter referred to as SNMP
IPv6). This does not affect the operation of the ATS
NET LED (green) indicates network communication status
ATS LED (yellow) indicates the ATS's communication status.
Sets up operation mode
Condition Meaning
OFF Ethernet is unlinked.
Green Ethernet is linked.
OFF 1. Initialization
2. SNMP IPv6 abnormality
Amber SNMP IPv6 abnormality
Every second Poor connection between the ATS and the SNMP IPv6
Blinking
Every 50 ms
DIP 2 Operation mode
OFF Normal mode
ON Pass through
mode
OFF -
ON Configuration
mode
Normal connection between the ATS and the SNMP IPv6
Description
The built-in SNMP IPv6 provides the ATS's status
information and parameters through a network
system.
The built-in SNMP IPv6 stops polling the ATS but
transfers the communication data between the
"LOCAL" port and the ATS.
Invalid state
In this mode, users can login through the "LOCAL"
port and configure the built-in SNMP IPv6's settings.
ATS-01_EN