Maintenance And Cleaning; Optional Accessories - Bosch GSC 4,5 Mode D'emploi

EURO • Printed in Germany • BA 1 609 929 075 • GSC 4,5 • GB • OSW 01/01
GSC 4,5 (075) - Buch Seite 3 Donnerstag, 11. Januar 2001 3:43 15
B
Cutter Clearance b
The position of the upper cutter must be at the
highest dead centre. To carry this out, turn the
screw in bore 11 using a screwdriver until the
height of the upper cutter is at its maximum.
Using a pin 15 screw in the ad-
justment
screw 6. Set the upper cutter 5
such that the vertical dis-
b
tance b between the upper
and lower cutter is 0.8 mm.
Tighten screw 6. Then turn the
adjustment screw 4 against
the cutter using pin 15.
For softer or more ductile materials, the clear-
ance b must be decreased; for harder or more
brittle materials, increased.
Sharpening the Cutters
C D
With the setting gauge 14 the knife distances a
and b can be checked, and with the template 13
the cutting angle of the knives.
When sharpening the cutters, take care that cut-
ting angles (grinding angles) are maintained.
Sheet metal can be cut more efficiently if the up-
per cutter is curved.

Optional accessories

Upper Cutter
Lower Cutter
Setting gauge
Gauge
Pin
Hex key 5 mm
Hex key 3 mm
Spanner 10 mm
Auxiliary Handle
1 609 929 075 • TMS • 08.01.01

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
screw 4. Loosen
B
After approx. 100 operating hours the entire
transmission lubricant should be changed.
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair
should be carried out by an authorised after-sales
service centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine it must be
disposed of safely.
Guarantee
3 608 635 000 We guarantee Bosch appliances in accordance
3 608 635 002
with statutory/country-specific regulations (proof
1 607 970 015 of purchase by invoice or delivery note).
1 607 970 016
Damage attributable to normal wear and tear,
1 607 990 001
overload or improper handling will be excluded
1 907 950 006
from the guarantee.
1 907 950 004
In case of complaint please send the machine,
1 907 950 504
undismantled, to your dealer or the Bosch Serv-
2 602 025 075
ice Centre for electric power tools.
English - 3
Lubricate the machine using transmission lu-
bricant (250 g, 5 700 052 025) at the lubrica-
tion point 12 after every 8 hours of operation.
Excess grease can escape from the eccen-
tric axle and the stroke mechanism. Lubrica-
tion should be carried out only when the ma-
chine is not under load.
strain relief
live = brown
neutral = blue
To be fitted
by qualified
professional only