Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EURO • Printed in Germany • BA 1 609 929 075 • GSC 4,5 • GB • OSW 01/01
GSC 4,5 (075) - Buch Seite 1 Donnerstag, 11. Januar 2001 3:43 15
Tool Specifications
Sheet Metal Shears
Part number
Rated power
Output power
Stroke rate at no load
Full-load stroke rate
Cutting thicknesses
2
Steel sheet (400 N/mm
)
2
Steel sheet (600 N/mm
)
Aluminium sheet (250 N/mm
2
INOX sheet (800 N/mm
)
Smallest curve radius
Weight (without
optional extras) approx.
Safety class
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 88 dB (A); sound
power level: 101 dB (A).
Wear ear protection!
The typical weighted acceleration is 3 m/s
Machine Elements
1 On/Off switch
2 Auxiliary handle
3 Cutting table
4 Adjustment screw, upper cutter
5 Upper cutter
6 Attachment screw (upper cutter)
7 Lower cutter
8 Nut
9 Set screw lower blade
10 Attachment screw (lower cutter)
11 Bore
12 Lubricating point
13 Gauge
14 Setting gauge
15 Pin
Not all of the accessories illustrated or described are
included as standard delivery.
1 609 929 075 • TMS • 08.01.01
GSC 4,5
0 601 508 0..
1 010 W
540 W
1 250 spm
840 spm
max. 4.5 mm
max. 3.6 mm
2
) max. 5.0 mm
max. 3.1 mm
25 mm
6.9 kg
/ II
2
.
English - 1
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed. Before using for the first
time, ask for a practical demon-
stration.
If the mains cable is damaged or
cut through while working, do not
touch the cable but immediately
pull the mains plug. Never use the
machine with a damaged cable.
Wear protective gloves and sturdy
shoes.
Wear protective glasses and ear
protection.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
Always direct the cable to the rear away from
the machine.
Always switch off the machine and allow to
come to a stop before placing it down.
Insert the mains plug only when the machine is
switched off.
When cutting, never place the hand in front of
the cutters.
Apply the machine to the workpiece only when
switched on.
Never allow children to use the machine.
Bosch is only able to ensure perfect function-
ing of the machine if the original accessories
intended for it are used.
Publicité
Table des Matières
