Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch GHO 10-82 Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-447-001.book Page 13 Monday, October 8, 2007 11:18 AM

Working Advice

Planing (see figure N)
Set the required planing depth and place the
front part of the planer base plate 8 against the
workpiece.
Apply the machine to the workpiece only
when switched on. Otherwise there is danger
of kickback when the cutting tool jams in the
workpiece.
Switch the machine on and guide the machine
with even feed over the surface to be planed.
To achieve high-grade surfaces, work only with
low feed and apply pressure on the centre of the
planer base plate.
When machining hard materials (e.g. hardwood)
as well as when utilising the maximum planer
width, set only low planing depths and reduce
planer feed, as required.
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
The integrated park rest 29 also allows for con-
tinued planing at any given location on the work-
piece after an interruption:
– With the park rest folded down, place the ma-
chine on the location of the workpiece where
the planing is to be continued.
– Switch on the machine.
– Apply the supporting pressure onto the front
part of the planer base plate and slowly push
the machine forward ( ). This tilts the park
rest upward ( ) so that the rear part of the
planer base plate faces on the workpiece
again.
– Guide the machine over the surface to be
planed ( ) with even feed.
Beveling Edges (see figure O)
The V-grooves in the front planer base plate allow
quick and easy beveling of workpiece edges. De-
pending on required bevel width, use the corre-
sponding V-groove. For this, place the planer
with the V-groove onto the edge of the workpiece
and guide it along the edge.
Bosch Power Tools
Groove to be
used
none
small
medium
large
Planing with Parallel/Beveling Guide
(see figures K–M)
Mount the parallel guide 21 or beveling guide 25
to the machine using the corresponding fasten-
ing bolt 24. Depending on the application, mount
the rebating depth stop 28 with fastening bolt 27
to the machine.
Loosen the locking nut 23 and adjust the request-
ed rebating width on the scale 22. Tighten the
locking nut 23 again.
Adjust the requested rebating depth accordingly
with the rebating depth stop 28.
Carry out the planing procedure several times un-
til the requested rebating depth is reached.
Guide the planer applying sideward supporting
pressure.
Beveling with the Beveling Guide
When beveling rebates
and surfaces, adjust the
required slope angle
with the angle adjust-
ment 26.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
Ensure easy operation of the park rest 29 and
clean it regularly.
1 609 929 M02 | (8.10.07)
English | 13
Dimension a
(mm)
0 – 4
2 – 6
4 – 9
6 – 10