Working Advice - Bosch Professional GBH 36 V-LI Compact Notice Originale

OBJ_BUCH-589-002.book Page 13 Friday, February 6, 2009 1:13 PM
Reversing the Rotational Direction
(see figure I)
The rotational direction switch 6 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 7 actuated.
Right rotation: Push the rotational direction
switch 6 left to the stop.
Left rotation: Push the rotational direction
switch 6 right to the stop.
For hammer drilling and drilling, always set the
direction of rotation to right rotation.
Switching On and Off
– To start the machine, press the On/Off
switch 7.
When starting the machine for the first time, a
starting delay is possible, as the electronic sys-
tem of the power tool has to configure itself
first.
– To switch off the machine, release the
On/Off switch 7.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on pow-
er tool can be variably adjusted, depending on
how far the On/Off switch 7 is pressed.
Light pressure on the On/Off switch 7 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
Safety Clutch
If the tool insert becomes caught or
jammed, the drive to the drill spindle is in-
terrupted. Because of the forces that occur,
always hold the power tool firmly with both
hands and provide for a secure stance.
If the power tool jams, switch the machine
off and loosen the tool insert. When switch-
ing the machine on with the drilling tool
jammed, high reaction torques can occur.
Bosch Power Tools
All manuals and user guides at all-guides.com
Temperature Control Indicator
The red LED of the temperature control indica-
tor 13 signals that the battery or the electronics
of the power tool (when the battery is inserted)
are not within the optimum temperature range.
In this case, the power tool will not operate at
full capacity.
Temperature control of the battery:
– The red LED 13 lights up continuously after
– The red LED 13 flashes when pushing button
– For battery temperatures over 70 °C, the
Temperature control of the power tool electron-
ics:
– The red LED 13 lights up continuously when
– At a temperature above 90 °C , the electron-

Working Advice

Vibration Damper
The integrated vibration damper reduces occur-
ring vibrations.
The soft grip handle increases the safety against
slipping off and thus provides for a better grip
and handling of the power tool.
inserting the battery into the charger: The
battery is not within the charging tempera-
ture range between 0 °C and 45 °C and can-
not be charged.
15 or pressing the On/Off switch 7 (when the
battery is inserted): The battery is not wihin
the temperature range for operation of
–10 °C to +60 °C.
power tool switches off until the battery is in
the optimal temperature range again.
pressing the On/Off switch 7: The tempera-
ture of the machine's electronics is below
5 °C or above 75 °C.
ics of the power tool switch off until the tem-
perature is within the allowable temperature
range again.
1 619 929 798 | (6.2.09)
English | 13