Auxiliary Handle - Bosch Professional GBH 36 V-LI Compact Notice Originale

OBJ_BUCH-589-002.book Page 10 Friday, February 6, 2009 1:13 PM
10 | English
To remove the battery 11:
– Push the battery against the base of the pow-
er tool (1.) and at the same time press the
battery unlocking button 12 (2.).
– Pull the battery out of the power tool until a
red stripe becomes visible (3.).
– Press the battery unlocking button 12 again
and pull out the battery completely.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 14 indicate the charge condition of
the battery 11. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
– Push button 15 to indicate the charge condi-
tion (also possible when the battery is re-
moved). The battery charge-control indicator
automatically goes out after approx.
5 seconds.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pushing button 15,
then the battery is defective and must be re-
placed.
During the charging procedure, the three green
LEDs light up one after the other and briefly go
out. The battery is fully charged when the three
green LEDs light up continuously. The three
LEDs go out again approx. 5 minutes after the
battery has been fully charged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
1 619 929 798 | (6.2.09)
All manuals and user guides at all-guides.com

Auxiliary Handle

Rotating the Auxiliary Handle (see figure A)
The auxiliary handle 16 can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
– Turn the wing bolt for adjustment of the aux-
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 1.
– Press the button for the depth stop adjust-
Capacity
The knurled surface of the depth stop 1 must
face downward.
≥2/3
– Insert the SDS-plus drilling tool to the stop
≥1/3
<1/3
Reserve
– Pull out the depth stop until the distance be-
Selecting Drill Chucks and Tools
For hammer drilling, SDS-plus tools are required
that are inserted in the SDS-plus drill chuck.
For drilling without impact in wood, metal, ce-
ramic and plastic as well as for screwdriving,
tools without SDS-plus are used (e.g., drills
with cylindrical shank). For these tools, a key-
less chuck or a key type drill chuck are required.
Operate your machine only with the auxilia-
ry handle 16.
iliary handle 10 in anticlockwise direction
and set the auxiliary handle 16 to the re-
quired position. Then tighten the wing bolt
10 again in clockwise direction.
ment 9 and insert the depth stop into the
auxiliary handle 16.
into the SDS-plus tool holder 2. Otherwise,
the movability of the SDS-plus drilling tool
can lead to incorrect adjustment of the drill-
ing depth.
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drill-
ing depth X.
Bosch Power Tools