Starting Operation - Bosch Professional GBH 36 V-LI Compact Notice Originale

OBJ_BUCH-589-002.book Page 12 Friday, February 6, 2009 1:13 PM
12 | English
Mounting the Dust Extraction Attachment
(see figure G)
For dust extraction, the dust extraction attach-
ment (accessory) is required. When drilling, the
dust extraction attachment retracts so that the
attachment head is always close to the surface
at the drill hole.
– Press the button for depth stop adjustment 9
and remove the depth stop 1. Press button 9
again and insert the dust extraction attach-
ment into the auxiliary handle 16 from the
front.
– Connect an extraction hose (diameter
19 mm, accessory) to the extraction sleeve
20 of the dust extraction attachment.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Adjusting the Drilling Depth on the Dust Ex-
traction Attachment (see figure H)
The required drilling depth X can also be adjust-
ed when the dust extraction attachment is
mounted.
– Insert the SDS-plus drilling tool to the stop
into the SDS-plus tool holder 2. Otherwise,
the movability of the SDS-plus drilling tool
can lead to incorrect adjustment of the drill-
ing depth.
– Loosen the wing bolt 24 on the dust extrac-
tion attachment.
– Without switching the power tool on, apply it
firmly to the drilling location. The SDS-plus
drilling tool must face against the surface.
– Position the the guide pipe 25 of the dust ex-
traction attachment in its holding fixture in
such a manner that the head of the dust ex-
traction attachment faces against the surface
to be drilled. Do not slide the guide pipe 25
further over the telescopic pipe 23 of the
dust extraction attachment than required, so
that as much as possible of the scale 23 on
the telescopic pipe remains visible.
– Retighten the wing bolt 24 again. Loosen the
clamping screw 21 on the depth stop of the
dust extraction attachment.
1 619 929 798 | (6.2.09)
All manuals and user guides at all-guides.com
– Move the depth stop 22 on the telescopic
– Tighten the clamping screw 21 in this posi-
Operation

Starting Operation

Inserting the Battery
– Set the rotational direction switch 6 to the
– Insert the charged battery 11 from the front
Setting the Operating Mode
With the selector switch for drilling/hammer
drilling 8, the operating mode of the machine is
selected.
Note: Change the operating mode only when the
machine is switched off! Otherwise, the ma-
chine can be damaged.
– To change the operating mode, turn the se-
pipe 23 in such a manner that the
clearance X shown in the figure corresponds
with the required drilling depth.
tion.
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
centre position to protect the power tool
against accidental starting.
into the base of the power tool. Push the bat-
tery completely into the base until the red
stripe can no longer be seen and the battery
is securely locked.
lector switch for "drilling/hammer drilling" 8
to the requested position.
Position for hammer drilling in con-
crete or stone
Position for drilling without impact
in wood, metal, ceramic and plastic
as well as for screwdriving
Bosch Power Tools