Nolan N43E AIR Sécurité Et Instructions D'utilisation page 20

2 Remove the latch from the helmet by pulling it outwards so that the latch inner
bayonet "A" comes out of its housing in the visor mechanism (see Fig. 19).
3 Follow the same steps on the right side of the helmet.
4 Remove the peak by holding its side end and bending it outwards so that the hole
"B" of the peak comes unhooked from the visor mechanism and the inner pawl
"C" inside the peak comes out of its housing in the visor mechanism (see Fig. 18).
5 Repeat the steps 1, 2, 3 and 4 of the visor assembly section.
•
(Available as an optional accessory)
®
1 PINLOCK INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adju-
stment external levers are turned inwards.
1.3 Place the Pinlock
file of the Pinlock
the visor.
1.4 Insert one side of the Pinlock
position (Fig. 21).
1.5 Widen the visor and fasten the other side of the Pinlock
pin (Fig. 22).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
re silicone-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that
both visors are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers
simultaneously upwards to increase the stretch (Fig. 23). This operation must be car-
ried out gradually. The maximum stretch is achieved when the pin adjustment exter-
nal levers are turned outwards.
WARNING!
The presence of dust between the two visors may produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be
replaced.
Regularly check the correct stretching of the inner visor to prevent the same from
moving and scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check
both for system correct assembly and stretching.
®
inner visor on the visor. WARNING: The silicone-sealed pro-
® inner visor should be in contact with the inner surface of
®
inner visor on one of the visor pins and hold it in
®
®
inner visor and check that the enti-
20
inner visor to the second