Chin Guard - Nolan N43E AIR Sécurité Et Instructions D'utilisation

INSTRUCTIONS FOR USE
The N 43 E AIR helmet is equipped with removable chin guard. It can be used
with different configurations (thanks to the accessories supplied in the box) as
described at the end of the paragraph. Using the helmet in its full configuration
(chin guard attached and visor closed) obviously guarantees the best protection
when compared to the other configurations.
• VISOR REMOVAL
1 Lift and remove the safety cover from the latch as shown in Fig. 1 A, rotate the
latch 90 degrees towards the front part of the helmet (see Fig. 1 B).
2 Remove the latch from the helmet by pulling it outwards so that the latch inner
bayonet "A" comes out of its housing in the visor mechanism (see Fig. 2).
3 Follow the same steps on the right side of the helmet.
4 Remove the visor by holding the side end of the visor and bending it outwards so
that the hole "B" of the visor comes unhooked from the visor mechanism and the
inner pawl "C" inside the visor comes out of its housing in the visor mechanism
(see Fig. 3).
• VISOR ASSEMBLY
1 Place the visor on the left visor mechanism paying particular attention to insert
the visor inner pawl "C" next to the lower part of the visor mechanism and the
hole "B" on the special circular projection of the same mechanism (see Fig. 3).
2 Place the left side latch on the visor mechanism and insert the inner bayonet "A"
in its special housing in the side mechanism (see Fig. 2).
3 Turn the latch 90° towards the rear part of the helmet. Carry out this operation by
pushing the latch towards the inside of the helmet. Fix the latch by positioning the
safety cover (see Fig. 1 A). Make sure the cover is firmly attached to the latch.
4 Follow the same steps on the right side of the helmet.
WARNING!!!
- Make sure that the system is working properly. Open and close the visor making
sure that the mechanism holds it in the different positions.
- Do not use the helmet if the visor has not been assembled properly.
- If the visor opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolan authorized dealer.
•

CHIN GUARD

1 CHIN GUARD RELEASE
1 Open the visor completely.
2 Pull the right chin guard release lever upwards and at the same time remove the
chin guard from the helmet, by pulling it towards the outside (Fig. 4). Perform the
same operation on the left side of the helmet.
14