Maico PushPull PP 45 O Notice D'installation page 69

CAUTION
!
Risk of injury/damage to unit from falling
drawer unit (3 kg). Sometimes the drawer
unit is hard to slide in. Ensure that you are
standing securely and cannot lose your bal-
ance and that there is no one under the unit.
When installing and removing the drawer
unit, support it from below with a hand.
10. Slide drawer unit into wall sleeve.
The profi le seal [6] on the outside of the
drawer is used for fi xing and avoidance
of false air. The motor connection cable
must not be strained when installed. When
sliding in the drawer ensure that the Oben/
Top sticker is facing upwards.
11. Press fan connection cable into notch (
arrow) so that it is fi xed and not strained.
12. With units (12 V DC)
PP 45 O
Insert enclosed plate [11] in the 2 locking
tabs so that it engages. Wire connector
[10] with the 12 V control cable of the
room air control ( diagrams in appendix).
Attach connector [10] on plate [11]
( Fig.) and connect with connector [9].
PP 45 K
13. With
Loosen screw for board cover, take off
board cover. Insert fan connection cable
[9] directly on board. Wire the 12 V control
cable of the room air control ( diagrams
in appendix). Fit board cover.
14. Attach front cover of internal housing at
top in two housing studs and swivel down
until front cover engages on locking lever.
Before putting on the front cover
i
of internal housing, the shutter must
always be open. To do this, switch on
PP 45 K or RC unit. For PP 45 O, set
the rotary knob to "Open".
PP 45 RC
15. With
 Chapter 9.5
9 Mounting | UK
units (12 V DC)
units (230 V AC)
69