Assembling The Supplied Telescopic Pole On The Subwoofer; Using The Protective Covers - dB Technologies ES-1203 Caractéristiques Techniques

English

ASSEMBLING THE SUPPLIED TELESCOPIC POLE ON THE SUBWOOFER

The subwoofer (ES1203 SUB) has three transport handles [Y]: Two on the sides and one at the top.
There is also an M20 threaded hole [Z] in the top for inserting the telescopic pole provided.
To assemble the telescopic pole:
• Screw the top (telescopic) part onto the lower (fixed) part with a clockwise movement
• Screw the resulting pole into the hole [Z] with a clockwise movement
Insert the adjustable pole into the hole [X] on a single top, or on a double top in the MONO configuration.
Refer to chapter 2, CONFIGURATION TYPES, for further information and for the maximum allowed installation
heights.

USING THE PROTECTIVE COVERS

Two protective bags are provided. To protect the system:
• Put the two tops and the cables into the smaller cover. Note that you can transport them separately, thanks
to the shoulder strap
• Put the larger cover over the subwoofer from above
• Attach the two covers together using the Velcro bands as shown. Two bands are at the back of the two
covers, thread the two smaller bands through the eyelets on the cover with the tops in it
• Put the two parts of the telescopic pole into the four eyelets at the top of the subwoofer cover and adjust
the straps
ES-1203 Cod. 420120253 REV. 1.0
37