Installation Examples; Installation On Stand; Installation On Subwoofer; Installation On Subwoofer With Pole - dB Technologies Ingenia IG1T Caractéristiques Techniques

English

4. INSTALLATION EXAMPLES

• To use 2 stacked speakers, you need the optional LP-IG accessory. For further information,
please refer to the instructions of this accessory.
• Always check that the handles, allowing the infra-red communication, are not obstructed;
never cover them and remove any dust or dirt deposits.
• No installation other than that shown here is allowed.

INSTALLATION ON STAND

1 or 2 INGENIA IG1T can be installed in configuration on an optional standard
tripod stand, with a pole having a diameter of 35 mm. The maximum permissible
height between the base of the speaker and the floor is 150 cm an IG1T. For 2
speakers, 120 cm.
ATTENTION!
• Use an appropriately sized stand with the central foot forward to
ensure proper stability.

INSTALLATION ON SUBWOOFER

Using the GSA-IG accessory during the installation, you can use the speakers (1 o
2) mounted on subwoofer. This allows to get an extremely compact system, with
great output power over the whole range of sound frequencies, installed on the
ground. Additional mechanical fixing, or fixing with straps, is required to properly
secure the installation. Once the installation is completed, follow the subwoofer
configuration instructions in the

INSTALLATION ON SUBWOOFER WITH POLE

It is possible to use a single speaker mounted on 35 mm diameter pole. Additional
mechanical fixing, or fixing with straps, is required to properly secure the
installation. The maximum permissible height between the base of the speaker
and the floor is 150 cm. Once the installation is completed, follow the subwoofer
configuration instructions in the
INGENIA IG1T
64
SUBWOOFER MATCHING
SUBWOOFER MATCHING
section.
section.
English
Cod. 420120237 REV. 1.1