dB Technologies ES-1203 Caractéristiques Techniques page 49

English
RETURNING TO THE HOME PAGE WHILE BROWSING
To return to the HOME page from a sub page,
select and confirm the symbol shown in figure 10.
Alternatively, hold button [5] pressed for a few seconds
(shortcut).
INPUT, OUTPUT AND AUX MIXERS
From the HOME page, hold button [5] pressed for
a few seconds to access the input, output and AUX
(auxiliary buses) mixer. The main pages are shown in
figure 11.
In the DOUBLE COLUMN STEREO
configuration, you cannot make any
adjustments from the SLAVE system. You
must set all the parameters on the MA-
STER system.
The mixer pages are:
• INPUTS mixer
• OUTPUTS mixer
• AUX mixer
To enter one of these 3 pages, select the
corresponding word INPUTS, OUTPUTS or AUX,
confirm and turn button [5].
The INPUTS page displays the CH1, CH2, CH3 and
Bluetooth® levels.
The OUTPUTS page only displays the levels of the
separate subwoofer sections and the system MAIN
(total) section.
The AUX section has the levels of the channels that
function as auxiliary buses in the mixer.
The latter section is especially useful when you want
personalised monitoring assigned to the AUX output
[6].
Consider the configuration shown in figure 12, in
which output [6] of the ES1203 system is connected
to a monitor.
You can, for example, use the INPUTS mixer to mix
four sources connected to the system inputs, and
make only two of them play through the connected
monitor by adjusting the AUX levels independently.
ES-1203
Figure 10
Figure 11
Figure 12
Cod. 420120253 REV. 1.0
49