Before Starting The Equipment - EINHELL CC-PO 1100/1 E Instructions D'origine

•
Fit the handles and, if applicable, the optional
anti-vibration handles securely to the machi-
ne body.
If you experience an unpleasant feeling or skin
discoloration on your hands while using the ma-
chine, stop your work immediately. Take adequate
breaks from your work. If you do not take ade-
quate breaks from your work, you could develop
hand-arm vibration syndrome.
You should evaluate the level of strain in relation
to the work involved and the use of the machine
and take adequate work breaks accordingly. This
will enable you to signifi cantly reduce the level
of strain over the whole period of work. Minimize
the risk to which you are exposed from vibrations.
Look after this machine with care in accordance
with the operating instructions.
If the machine is deployed or used often, you
should consult your dealer and possibly consider
obtaining anti-vibration accessories (handles).
Do not use the machine at temperatures of
t=10°C or lower. Think out a work plan which ena-
bles you to limit your exposure to vibrations.
A certain level of noise nuisance is inevitable with
this equipment. Carry out noise-intensive jobs
at times that are acceptable and allowed. Where
applicable, observe rest periods and restrict your
working time to a minimum. Suitable ear protec-
tion must be worn for your own safety and for the
safety of others nearby.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Assembly (Fig. 4-6)
Important! Pull out the mains power plug before
starting the assembly work.
Only press the spindle lock once the machine is
stopped.
Anl_CC_PO_1100_1_E_SPK9.indb 18 Anl_CC_PO_1100_1_E_SPK9.indb 18
GB
6. Operation
Secure your workpiece. Make sure that the work-
piece is held securely by a clamping device or a
vise.
Switching the equipment ON/OFF
The equipment is turned on (I) and off (0) with
the ON/OFF switch (Fig. 3 / Item 3). However, the
equipment will only start running after the speed
control has been activated (see section 6.3).
Before switching off , lift the machine off the sur-
face to the worked.
6.1 Using as a polishing machine
Only use special waxing and polishing agents
suitable for the machine.
When using waxing and polishing agents,
observe the instructions issued by their ma-
nufacturer!
The Velcro fastener enables easy changing of the
polishing attachment.
CAUTION!
To prevent damage to the surfaces of the work-
pieces you wish to polish, make sure that you
observe the following instructions:
•
Wash the vehicle before polishing, and keep it
free of any foreign bodies.
•
Make sure that the polishing attachment
supplied is free of any foreign bodies when
being used.
•
Make sure that the polishing attachment is
always mounted precisely in the center of the
sanding/grinding disk.
•
Before you start the equipment, check to en-
sure that the attachments are securely fitted.
•
Never touch the area you wish to polish with
the edge of the sanding/grinding disk.
•
To polish, select the speed required for your
purposes using the speed controller (see
section 6.3). The optimum working speed de-
pends on the material to be worked and the
(polishing) agent used. If necessary, this can
be established by conducting practical tests.
•
The polishing machine must lie fully on the
surface to be polished.
•
Mask plastic parts, since these change color
when polished and can become unattractive
in appearance.
•
Only polish in the shade, and never polish hot
paint.
- 18 -
13.02.2020 09:53:30 13.02.2020 09:53:30