Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Make sure the power sockets used for battery charger are connected to a suitable earth system and protected by
differential thermal solenoid switches.
•
It is indispensable to respect the battery manufacturer's instructions and current legislation. The batteries should
always be kept clean and dry to avoid surface leakage current. Protect the batteries from impurities such as metal dust.
nEvER rest tools on the batteries as this could cause short circuit and explosion.
•
•
When using battery acid, always follow the relative safety instructions scrupulously.
•
To recharge the batteries, always use the battery charger supplied with the machine (when provided).
•
In the presence of particularly strong magnetic fields, assess the possible effect on the control electronics.
•
nEvER wash the machine with water jets.
•
The fluids collected during operation contain detergent, disinfectant, water, organic and inorganic material. They must
be disposed of in accordance with current legislation.
•
In the case of malfunction and/or faulty operation, turn the machine off immediately (disconnecting it from the
batteries) and do not tamper. Contact a service centre authorised by Dustbane.
•
All maintenance operations must be performed in an adequately lit place and only after disconnecting the machine
from the power supply (in battery models by disconnecting the batteries).
•
All work on the electrical system and all maintenance and repair operations (particularly those not explicitly described
in this manual) must be performed by specialised personnel expert in the sector only.
•
Only original accessories and spare parts supplied by the Manufacturer may be used in order to guarantee safe
problem-free operation of the machine. Never use parts removed from other machines or from other kits.
Handling And Installation
During all lifting operations, make sure the packaged machine is firmly anchored to avoid it tipping up or being
accidentally dropped. Always load/unload lorries in adequately lit areas.
Lifting And Transporting The Packaged Machine
The machine, packaged on a wooden pallet by the Manufacturer, must be loaded using suitable equipment and subsequent
amendments and/or additions) onto the transporting vehicle. At destination, it must be unloaded using similar means.
The squeegees are packed in cardboard boxes without pallet. A fork lift truck must always be used to lift the packaged body of the
machine. Handle with care to avoid knocking or overturning the machine.
Checks On Delivery
When the carrier delivers the machine, make sure the packaging and machine are both whole and undamaged. If the machine is
damaged, make sure the carrier is aware of the damage and before accepting the goods, reserve the right (in writing) to request
compensation for the damage.
Power Supply Batteries
Two different types of battery may be installed on these machines:
•
AGM batteries: the electrolyte level must be checked regularly. When necessary, top up with distilled water until the
plates are covered. Do not overfill (5 mm max. above the plates).
•
Gel batteries: this type of battery requires no maintenance.
The technical characteristics must correspond to those indicated in the paragraph on the technical specification of the machine.
The use of heavier batteries could seriously jeopardise manoeuvrability and lead to the brush motor overheating. Batteries with a
lower capacity and weight will require recharging more frequently. They must be kept charged, dry and clean and the connections
must be tight.
Follow the instructions below to set the type of battery installed on the machine's software.
Mechanical drive version:
1.
Turn the machine on by pressing the button (fig. 6, ref. 3), wait 5 seconds and make sure the display comes on.
2.
Press the brush buttons (fig. 6, ref. 3) and suction button (fig. 6, ref. 2) together for at least 5 seconds. This accesses the
battery setting menu.
3.
Press the suction button (fig. 6, ref. 2) to select the type of battery installed on the machine "ACd" for acid batteries
(AGM batteries) or "GEL" for gel batteries.
4.
Memorise the displayed parameter by pressing the button (fig. 6 ref. 3).
5
Publicité
Table des Matières
