Routine Maintenance - Dustbane Hurricane Serie Manuel D'opération

Routine Maintenance

Suction motor air filter and float switch: cleaning
• Unscrew and remove the tank cap (fig. 10, ref. 1) from the dirty water drum (fig. 10, ref. 4);
• Make sure the dirty water drum (fig. 10, ref. 4) is empty;
• Clean the float switch (fig. 10, ref. 5) at the back of the dirty water drum, taking care not to direct the water jet directly against
the float switch;
• Remove the suction motor air filter (fig. 10, ref. 2) from the float switch support (fig. 10, ref. 3) inside the dirty water drum at the
top;
• Clean the filter with running water or the detergent solution used on the machine;
• Dry the filter thoroughly before replacing it in the support. Make sure the filter is correctly located in its housing;
Fig./Abb. 9 Fig./Abb. 9
• Screw the cap back on the dirty water drum.
фиг./реф. 9 фиг./реф. 9
Basket filter: cleaning
• Remove the basket filter from the water fill hole at the front of the machine;
• Clean the filter with running water or the detergent solution used on the machine;
• Replace the filter back in its housing, making sure it is correctly positioned.
Detergent filter: cleaning
• Unscrew the screw located below the bottom tank (fig. 11, ref. 1);
• Unscrew the detergent filter (fig. 11, ref. 2);
• Clean the filter with running water or the detergent solution used on the machine;
• Replace the filter back in its housing, making sure it is correctly positioned and retighten the screw.
1
4
Fig./Abb. 10 Fig./Abb. 10
Squeegee blades: replacing
фиг./реф. 10 фиг./реф. 10
The squeegee blades collect the film of water and detergent from the floor and prepare the way for perfect drying. With time, the
constant rubbing leaves the edge of the blade in contact with the floor rounded and cracked, reducing the drying efficiency and
requiring it to be replaced.
Turning or replacing the blades:
• Lower the squeegee by means of the corresponding lever (fig. 6, ref. 8);
• Remove the squeegee (fig. 2 ref. 6) from its mount (fig. 7 ref. 2) by completely unscrewing the two knobs (fig. 7 ref. 3)
• Remove the suction hose sleeve (fig. 7, ref. 4) from the squeegee;
• Use a screwdriver to unscrew the bolt (fig. 12, ref. 3 or 6);
• Remove the two blade retainers (fig. 12 ref. 2 or 7) by first pushing them towards the body of the squeegee (fig. 12 ref. 1) then
extracting them;
• Remove the blade (fig. 12 ref. 4 or 5);
• Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a new
blade, fitting it onto the screws on the body of the squeegee (fig. 12 ref. 1);
16
1
1
4
5 5
2,3 2,3
4 4
3 3
2 2
1
Fig./Abb. 8 Fig./Abb. 8
фиг./реф. 8 фиг./реф. 8
Fig. 10
Fig./Abb. 11 Fig./Abb. 11
фиг./реф. 11 фиг./реф. 11
1,2 1,2
2 2
1 1
Fig. 11