Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Draining The Clean Water
DANGER: Use suitable personal protection devices. Drain the water with the machine disconnected from the power supply.
To empty the tank:
•
Move the machine near a drain;
•
Remove the cap (fig. 9, ref. 1);
When the detergent tank is completely empty, replace the cap (fig. 9, ref. 1).
TIP: The water and detergent solution can also be used to wash the dirty water drum.
Periods Of Inactivity
If the machine is not used for some time, remove the squeegee and brushes (or drive disks), wash them and put
them away in a dry place (preferably in a bag or wrapped in plastic film) away from dust. Park the machine with the
head lowered. Make sure the tanks are completely empty and perfectly clean. R models with rollers: empty the
debris bin (fig. 17). Disconnect the machine from the power supply (depending on the model, unplug from the
mains or disconnect the connector from the battery wiring).
Completely recharge the batteries before storing them. During long periods of inactivity, you should charge the batteries regularly
(at least once every two months) to keep them constantly at maximum charge.
IMPORTANT: If you do not charge the batteries regularly, they may be irrevocably damaged.
Battery Maintenance And Charging
DANGER: Do not check the battery by sparking. The batteries give off flammable fumes. Put out all fires and hot embers before checking or
topping up the batteries. Perform the operations described above in a ventilated room.
To avoid permanent damage to the batteries, do not run them down completely. Remember that when the corresponding red LED
(fig. 6, ref. 1) flashes on the control panel, you must charge the batteries.
Recharging Procedure
•
Connect the battery charger connector to the battery wiring connector (fig. 5, ref. 1);
IMPORTANT: In the case of gel batteries, use a charger specific for gel batteries only.
•
Charge the batteries as described in the battery charger manual;
•
At the end of charging, disconnect the connectors;
•
Reconnect the battery wiring connector to the machine connector.
Maintenance Instruction
DANGER: Never perform any maintenance operations without first disconnecting the batteries. Maintenance on
the electrical circuit and all other operations not explicitly described in this manual must be performed by
specialised personnel only, in compliance with current safety legislation and as described in the maintenance
manual.
Maintenance - General Rules
Performing regular maintenance according to the manufacturer's instructions improves performance and extends the working life
of the machine. When cleaning the machine, respect the following:
•
Avoid the use of high pressure washers. Water could penetrate the electrical compartment or motors leading to damage or the
risk of short circuit;
•
Do not use steam to avoid the heat warping plastic parts;
•
Do not use hydrocarbons or solvents as they could damage the cowling and rubber parts.
15
Publicité
Table des Matières
