Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Reposition the two blade retainers (fig. 12 ref. 2 or 7) by centering the widest part of the slots over the fixing screws on the
squeegee body (fig. 12 ref. 1), then pushing the blade retainers inwards;
•
Screw up the bolt (fig. 12, ref. 3 or 6).
•
Replace the squeegee in its support following the instructions in paragraph 6.2.
1
5
7
3
7
Fig./Abb. 12
Fuses: Replacement
фиг./реф. 12
The fuses protecting the brush and suction motors are located in the fuse holder (fig. 13, ref. 1) attached to the dirty water drum
above the machine battery compartment.
To replace the fuses:
•
Make sure the dirty water drum is empty and empty if necessary;
•
Raise the dirty water drum;
1
•
Raise the fuse holder cover and remove the fuse by unscrewing the fixing screws;
•
Fit a new fuse and close the fuse holder cover;
•
Lower the dirty water drum.
Fuse table: For the complete fuse table, see the parts list.
IMPORTANT: Never use a fuse with a higher amperage than specified. If a fuse continues to blow, the fault in the wiring, boards (if present)
or motors must be identified and repaired. Have the machine checked by qualified personnel.
Fig./Abb. 13
фиг./реф. 13
Fig. 7
1
5
7
3
7
Fig./Abb. 12
фиг./реф. 12
1
Fig./Abb. 14
фиг./реф. 14
1
2
3
Fig. 13
Fig./Abb. 13
фиг./реф. 13
2
6
2
4
Fig. 12
A
Fig./Abb. 14
фиг./реф. 14
17
Publicité
Table des Matières
