Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"V" squeegee
•
Lower the squeegee by means of the squeegee lever (fig. D, ref. 2);
•
Remove the suction hose sleeve (fig. E, ref. 8) from the squeegee;
•
Remove the squeegee from its mount (fig. E ref. 6) by completely unscrewing the two knobs (fig. E ref.7);
•
Remove the blade pressing devices by opening the catch (Fig. E, ref. 11);
•
Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a
new blade, fitting it onto the screws on the body of the squeegee;
•
Reposition the two blade pressing devices and the blades, closing the catch.;
•
Replace the squeegee in its support following the instructions in the section "Mounting and adjusting the squeegee".
Fuses: replacement
The fuse protecting the electrical circuit is located on the battery bridge. To replace it:
•
Make sure the dirty water tank is empty and empty if necessary;
•
Remove the dirty water tank to access the batteries;
•
Lift the fuse holder lid (fig. L) and remove the fuse;
•
Fit a new fuse and close the fuse holder cover.
•
Lower the dirty water tank.
Fuse table: for the complete fuse table, see the spare parts catalogue.
IMPORTANT - Never use a fuse with a higher amperage than specified.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be identified and repaired. Have the machine
checked by qualified personnel.
Routine maintenance
Daily operations
After each day's work, proceed as follows:
•
Disconnect the machine from the power supply;
•
Empty the dirty water tank and clean if necessary;
•
Clean the squeegee blades and check for wear. If necessary, replace.
•
Check that the suction hole in the squeegee is not blocked, if necessary remove encrusted dirt;
•
Charge the batteries according to the procedure described;
Weekly operations
•
Clean the dirty water tank float switch and make sure it is working correctly;
•
Clean the suction hose;
•
Clean the dirty water tank and detergent tank;
•
Check the level of battery electrolyte and top up with distilled water if necessary;
Six monthly operations
Have the electrical circuit checked by qualified personnel.
13
Publicité
Table des Matières
