Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Working
After setting up the machine, proceed as follows.
•
Lower the squeegee using the lever provided (Fig. C, ref. 2), standard version with brushes and drive disks;
•
Press the main switch (Fig. C, ref. 3) (LED on);
•
Press the brush button (Fig. C, ref. 4) "LED on", this will also automatically activate suction and solution flow. To extend
machine operating time, the ECO function can be activated (see the paragraph "Controls - Descriptions");
•
Select the direction of movement by pressing the button (Fig. D, ref. 4)
•
Adjust the forward/reverse speed by turning the potentiometer (Fig. D, ref. 5)
•
Press the brush lever (Fig. C, ref. 1);
•
Check regularly that detergent is reaching the brushes and top up if necessary;
•
While working, check the quality of washing and adjust the flow of detergent to the brushes using the detergent tap;
IMPORTANT - Empty the dirty water tank each time you fill the detergent tank.
•
The float switch in the dirty water tank (fig. I, ref. 1) turns suction off when the tank is full. If the switch trips, stop work
and empty the tank;
•
If the red LED (fig. C, ref. 2) starts flashing, the batteries are nearly flat. After a few seconds, the brush and suction motor
shut down to prevent draining the batteries excessively. Charge the batteries.
At the end of work:
•
Release the brush lever (fig. D, ref. 1);
•
Turn the machine off by pressing the button (fig. C, ref. 3) for at least 4 seconds.
•
Use the lever provided (Fig. D, ref. 2) to raise the squeegee off the floor and prevent continuous pressure from deforming
the drying blades, standard version with brushes and drive disks;
•
Remove the brush (or drive disk) to prevent it from warping permanently;
•
Use the handle to raise the front of the machine and fit the transport wheel, thus preventing continuous pressure from
deforming the drying blade.
•
Disconnect the batteries,
•
Empty and clean the dirty water tank.
Some useful tips to get the most from your scrubber drier
In the event of particularly stubborn dirt on the floor, washing and drying can be performed in two separate operations.
Prewashing with brushes or pads
•
Press the main switch (fig. C, ref. 3) (LED on);
•
Press the brush button (fig. C, ref. 4) (LED on);
•
Press the suction button (fig. C, ref. 5) (LED off ) to turn suction off;
•
Operate the brush lever (fig. D, ref. 1) to enable brush rotation;
•
Make sure the suction motor is off and the squeegee is raised;
•
Begin washing.
•
Adjust the flow of detergent to the brush by means of the detergent tap (fig. G, ref. 2). Flow speed must be regulated
according to the operator's chosen advance speed. The slower the machine moves forwards, the less water is needed.
Persist when washing particularly dirty points to give the detergent time to perform its chemical action detaching and
suspending the dirt and the brushes time to exert an effective mechanical action.
10
C
Publicité
Table des Matières
