Handle Assembly; Operational Instructions; Use Of The Onboard Battery Charger - Dustbane Gladiator 464 Manuel D'opération

Masquer les pouces Voir aussi pour Gladiator 464:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Handle assembly

• Raise the front part of the machine.
• Slide the brush on to the shaft until it locks into place.

OPERATIONAL INSTRUCTIONS

ATTENTION: This machine is not intended for wet surface sweeping. However, if you encounter a slightly damp environment (moisture
buildup on the floor), it is required that you turn the vacuum fan switch off to prevent filter damage. Machine damage due to wet debris
pickup is not covered under warranty.
ATTENTION: If the sweeper is lying inactive for a period longer then one month you must disconnect the red and black battery clips. If the
sweeper is lying inactive for a period longer then one week you should leave it connected to the electrical outlet.
After having followed all operations for starting the machine you are now ready to work with the machine as a sweeper. To achieve
the maximum performance follow the proceedures in this manual to avoid the risk of damaging the machine. It is important:
• Not to use the machine for collecting wires, ropes, strings, water or other liquids
• In the presence of large volume debris (paper, leaves, etc.) raise the front part of the machine by pushing down the
handle bar. Shake the filter at the end of the working session

Use of the Onboard Battery Charger:

When the battery on the machine is discharged, the red led on the control panel illuminates and all functions of the machine will
automatically stop: the operator must then turn off the machine and start the charging procedure by connecting the machine
battery charger plug into an AC electrical outlet. (during charging the yellow led on the display will be lit): when the machine is fully
charged the green led will be lit, the battery charger plug can be disconnected and the machine is ready for operation.
IMPORTANT NOTE: Using the machine before the battery has fully charged and a green light displayed will reduce the life and run time of
your battery and void the warranty. THE ON-BOARD CHARGER IS SPECIFICALLY DESIGNED FOR
SEALED BATTERIES.
NOTE: If during working mode the machine battery charger plug is connected, the machine will automatically stop all
its functions. Such operation is forbidden.
8
Operations Manual
Gladiator 464/664

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gladiator 6641967719680

Table des Matières