Machine Preparation; Side Brush Assembly - Dustbane Gladiator 464 Manuel D'opération

the batteries from impurities such as metal dust.
• Never rest tools on the batteries as this could cause short circuit and explosion.
• When using battery acid, always follow the relative safety instructions scrupulously.
• In the presence of particularly strong magnetic fields, assess the possible effect on the control electronics.
• Never wash the machine with water jets.
• The fluids collected contain detergent, disinfectant, water and organic and inorganic material.
They must be disposed off in accordance with local legislation.
• In the case of malfunction and/or faulty operation, turn the machine off immediately (disconnecting it from the main
power supply or batteries) and do not tamper. Contact a service center authorized by the Manufacturer.
• All maintenance operations must be performed in an adequately lit place and only after disconnecting the machine from
the power supply.
• All work on the electrical system and all maintenance and repair operations other than those explicitly described in this
manual must be performed by specialized personnel expert in the sector only.
• If the power cable, plug or terminals require replacing, make sure the electrical connections and cable grip inside the
control panel are tightly fastened to guarantee the resistance of the cable if pulled. Then replace the panel carefully to
guarantee the safety of the operator.
• Only original accessories and spare parts supplied by the Manufacturer may be used in order to guarantee safe problem-
free operation of the machine. Never use parts removed from other machines or from other kits.
• This machine has been designed and constructed to provide ten years' service from the fabrication date shown on the
rating plate (fig. 1). After this time, whether the machine has been used or not,
it should be disposed of according to current legislation in the country in which it is used:
• At the end of the machine's life, please dispose according to local regulations.
The machine is designed and constructed to provide ten years' service from the date of manufacture shown on the nameplate.
After this period, whether the machine has been used or not, it should be disposed of according to current legislation in the
country in which it is used.
It should be disconnected from the power supply, emptied of all liquids and cleaned prior to disposal.
The machine is classified as WEEE-type special waste and is covered by the requirements of applicable environmental protection
regulations (2002/96/EC WEEE).
The machine must be disposed of separately from ordinary waste in compliance with current legislation and standards.
Also make sure that all parts of the machine that could represent a hazard, particularly to
children, are made safe.
Alternatively, return the machine to the Manufacturer for a complete overhaul.

MACHINE PREPARATION

Side brush assembly

• Raise the front part of the machine.
• Slide the brush on to the shaft until it locks into place.
Operations Manual Gladiator 464/664
7