Actuator Function; Adjusting The Side Brush - Dustbane Gladiator 464 Manuel D'opération

Main Filter
The Main filter can be cleaned in any of the following three ways:
• By means of the automatic filter shaker: During operation, the machine will automatically activate the filter shaker every 3
minutes.
• By means of manually activating the filter shaker: Just a simple command is needed to keep the filter in perfect working
order: press the button marked 'E' and hold it down for a few seconds. Repeat this operation 4 or 5 times. Remember that
the cleaner the filter, the better the results of your cleaning session. It is recommended to carry this good idea to use the
manual filter shaker more frequently.
• By manually cleaning the filter: Manually clean the filter when the filter shaker is not enough to keep the filter clean and/
or every 20 hours of work. Before carrying out any kind of procedure on the machine, make sure it is turned off and that
all functions are deactivated.
Filters in Rear Hopper
• Remove the rear hopper
• Take the filter out
• Blow compressed air into the side of the filter (at a pressure of 87
psi at the most). Safety glasses required.
• Reinstall the filters and the rear hopper.

Actuator Function

The system allows the brush to immediately and constantly follow all types of surfaces, self adjust to surfaces and self adjust for
main/side brush wear through out the life of the brushes.

Adjusting the side brush

To adjust the side brush, remove the top cover, and turn adjusting handle in the direction required.
Flap Raiser (664 only)
To pick up bulky rubbish, raise the flap using the lever on the handlebar. You should not use the appliance with the flap raised for
longer than necessary as the cleaning efficiency is reduced.
Operations Manual Gladiator 464/664
11