Maintenance Instructions; Waste Hopper Emptying And Cleaning - Dustbane Gladiator 464 Manuel D'opération

Working
ATTENTION: The machine must be used only by authorized personal, DO NOT ABANDON the machine when switched on, do not use
the machine for collecting liquid, turn the machine OFF before leaving the machine. FOR SAFETY; DO NOT OPERATE MACHINE UNLESS
OPERATION MANUAL IS READ AND UNDERSTOOD.
To start the machine use the following procedures:
• Press the main ON/OFF button
• Check the that the green led is lit indicating a proper battery charge level
• Select the appropriate sweeping mode: ON/OFF sweeping mode button 1 - for light debris and smooth surfaces. ON/OFF
sweeping mode button 2 - for heavy debris and concrete, asphalt and carpeted surfaces.
INFORMATION: Using sweeping mode 2 will reduce the maximum machine run time.

MAINTENANCE INSTRUCTIONS

! DANGER: Never perform any maintenance operations on the machine without first removing the battery pack (battery
poweredmodels).
! WARNING: Before proceeding with any maintenance operation on the machine, always be sure to empty the detergent tank and the
dirty water tank, referring to the relative sections "Emptying the water/detergent tank" and "Emptying the dirty water tank".
! INFORMATION: Maintenance operations involving the electrical system, and in any event all servicing or repair operations not explicitly
described in this manual, must be entrusted to a specialist technician approved by Dustbane or carried out at an Dustbane service
centre, inaccordance with current safety regulations. Ensure the machine undergoes regular maintenance, so that it will always deliver
optimum performance. Do not clean seals with ethyl alcohol.

Waste Hopper emptying and cleaning

!DANGER: Before proceeding in removing the hopper assure that the machine is turned off.
Waste disposal must be done by following the laws in force. To clean the waste hopper proceed as follows:
• Release the hopper clamp by lifting and then pushing on the back of the clamp.
• Pull out the hopper by its handle
• Empty the hopper.
To put back the hopper proceed as follows:
• Slide the hopper back into place
• Lower and press the hopper clamp to lock into place
Operations Manual Gladiator 464/664
9