Dustbane Hurricane Serie Manuel D'opération page 16

The battery discharges too fast during use, recharging with an electronic battery charger is too fast and after
recharging the battery supplies the right voltage (about 2.14v for each element without load), but when
The battery supplied filled with acid by the Manufacturer has
been stored for too long before being charged and used for the
first time.
At the end of charging with the electronic battery charger, the battery does not provide the correct voltage
(about 2.14 v per element without load) and appears to be uniformly not charged when tested with a
The battery has not been connected to the battery charger (for
example, because the low voltage connector of the battery
charger has been erroneously connected to the machine
connector).
The battery charger and power socket to which the battery is
connected are not compatible.
The battery charger has not been installed correctly.
The battery charger is not working.
One or more elements are damaged.
The battery has reached the end of the charging/ discharging
cycles declared by the manufacturer.
The battery has been charged with too high of a current.
The battery has been charged beyond the limit suggested by
the Manufacturer.
16
tested with hydrometer is found not to be uniformly charged
CAUSE
CAUSE
The electrolyte in the battery is turbid
CAUSE
PROBLeM:
if recharging with a normal battery charger is not effective, you
must use a double recharging cycle:
- charge it slowly over a 10 hour period at a current of 1/10 the
nominal capacity for 5 hours (e.g. for a 100Ah(5) battery the
current must be set at 10A, using a manual battery charger);
- rest for one hour;
- charge it with the normal battery charger.
PROBLeM:
hydrometer
Connect the battery charger to the battery connector.
Check that the power supply characteristics indicated on the
battery charger rating plate comply with those of the mains
power supply.
Taking the actual voltage available at the socket into account,
make sure that the connections of the primary of the
transformer inside the battery charger are correct (consult the
battery charger manual)
Make sure there is voltage to the battery charger, that the
fuses are not blown and that the current reaches the battery;
try charging with another rectifier. If the battery charger is not
working, contact the technical service centre and indicate the
serial number of the battery charger.
Replace the damaged elements if possible. For 6 or 12 V single
block batteries, replace the entire battery
PROBLeM:
Replace the battery.
Replace the battery.
Replace the battery.
SOLUTION
SOLUTION
SOLUTION