Mounting And Changing The Brush/Drive Disks - Dustbane Hurricane Serie Manuel D'opération

"V" squeegee (Hurricane 450 XTT)
1.
Check that the squeegee mount (6) is lowered, otherwise lower it by means of the squeegee lever (A);
2.
Insert the two threaded pins (13) on the squeegee into the slots on the support (6);
3.
Fix the squeegee by tightening the two knobs (7);
4.
Insert the sleeve of the suction hose (8) fully into the squeegee;
The squeegee blades scrape the film of water and detergent from the floor and prepare the way for perfect drying. With time, the
constant rubbing makes the edge of the blade in contact with the floor rounded and cracked, reducing the drying efficiency and
requiring it to be replaced. The state of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during operation by about
45° with respect to the floor at every point. Adjust the height of the blade during operation by regulating the height of the wheels
positioned on the squeegee (9). The slope of the squeegee can also be varied by tightening or loosening the screw (10).
To move the machine, proceed as follows:
•
Lift the squeegee using the lever provided (A) for parabolic squeegee and "V" squeegee;
•
Raise the front of the machine off the floor using the handle, then move it to the destination; if the transport wheel is
fitted, lift the machine using the handle (standard on the roller version) so that it rests on the wheel.
•
On arrival, lower the front of the machine.
•

Mounting and changing the brush/drive disks

IMPORTANT - Never work without the brushes and drive disks correctly installed.
Standard version with brushes and drive disks
Brush/drive disk attachment: turn the machine on by pressing the main switch (3) (LED on),
then press the brush button (4) (LED on). Rest the brush on the floor in front of the machine.
Raise the front of the machine by levering on the handle, then lower it onto the brush, centring
it with the brush cover. Operate the brush lever (A) repeatedly until the brush automatically
engages on the flange hub. If the manoeuvre is not successful, press on the handle again and
repeat the centring and repeated operation of the brush lever.
8