Handling And Installation - Dustbane Hurricane 700 XTT Manuel D'opération

Masquer les pouces Voir aussi pour Hurricane 700 XTT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Make sure that the electric characteristics of the machine (voltage, frequency, absorbed power) indicated on the identification
plate (fig. 1), are compliant with those of the power distribution plant.
It is fundamental to observe the battery manufacturer's instructions and stick to the Legislator's provisions. Keep batteries
always dry and clean to avoid surface leakage currents. Keep batteries safe from impurities, for instance metal dust.
DO nOT lay tools on batteries: danger of short circuits and explosions.
Mind the use of battery acid: stick to the relative safety instructions.
In presence of particularly high magnetic fields assess the possible effects on the control electronics.
nEvER wash the machine with jets of water.
The recycled fluids contain detergents, disinfectants, water, organic and inorganic stuff recycled during the work stages: they
must be disposed of in compliance with the laws in force.
In case of breakdown and/or bad operation of the machine, switch it off immediately (unplugging it from the mains) and do not
tamper with it. Contact a technical assistance centre of the manufacturer's.
All maintenance operations must be performed in adequately lighted environments and only after having disconnected the
machine from the power supply (by detaching the battery connector).
Have any electrical work and all maintenance and repair operations (particularly those not explicitely described in this manual)
carried out a specialised and trained technical staff only.
In case of replacement of the plug or terminals, perform the repair by properly fixing the electric connections and the cable
blocking strap that is located in the control panel, to guarantee the resistance of the cable. Then reassemble the panel with care
to ensure the protection of the machine user.
Only the use of original accessories and spare parts supplied by the manufacturer is permitted, as only these offer the certainty
that the machine will operate safely and without any inconveniences. DO nOT use parts removed from other machines or other
kits as spares.
This product is classified as RAEE type special waste and is covered by the requisites of the new environmental protection
regulations (2002/96/CE RAEE). It must be disposed of separately from ordinary waste in compliance with current legislation
and standards.
Special waste. DO nOT dispose of with ordinary waste.
Alternatively, the machine can be sent to the manufacturer for a thorough overhaul. If the machine is not used anymore, it is
recommended that batteries are removed and deposited at an authorized collecting centre. Moreover, it is recommended that you
make harmless those parts of the machine that could be dangerous especially to children, who could use the machine for their
games.

Handling And Installation

Lifting And Carrying The Packed Machine
In all lifting operations make sure that the packed machine has been tightly anchored to the pallet, in order to avoid any overturning or
accidental falls. Loading and/or unloading from the motor vehicles must be performed in an adequately lighted environment.
The machine, which is packed on a wooden pallet by the manufacturer, must be loaded by means of proper handling machines
(refer to the EEC provision 89/392/CEE and following amendments), onto the carrier and, once it has arrived at the appointed
destination, unloaded by similar means.
The brushes and the squeegees are packed in cardboard boxes without pallet. The packed machine body must be lifted only with a
fork lift truck. Handle with care to avoid bumps or overturnings.
Checking The Machine On Delivery
On delivery check with attention that the package and the machine are not damaged. In the event that the machine has suffered
any damages, report so to the carrier; before accepting the goods, reserve by written the right to present a claim for the refund of
the damages.
Unpacking
On unpacking the machine, the operator must be provided with the necessary accessories (e.g. gloves, protective goggles etc.) to limit
possible hazards of accidents.
6

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hurricane 850 xtt1932319324

Table des Matières