Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before opening the upper tank: ensure that the recovery tank is empty (an acoustic warning device will sound if you try to open the recovery
tank without emptying it first); ensure that the emergency button is pressed.
5.
Insert the batteries in the compartment, orienting them as shown in the drawing printed on the solution tank in the compartment.
Install the storage batteries on the machine using suitable means according to their weight. Positive and negative poles have
different diameters.
6.
Referring to the arrangement of cables in the aforesaid drawing, connect the clips of the battery wiring and the bridge to the
poles of the storage batteries. After orienting the cables as shown in the drawing, tighten the clips at the poles and cover them
with vaseline;
7.
Insert back the tank unit in its work position and hook it to the solution tank by means of the fixing hook (fig. 7, ref. 1);
8.
Use the machine in compliance with the instructions written below.
Batteries: Removal
When removing the batteries, the operator must be equipped with suitable personal protection devices (gloves, goggles, overalls, safety
shoes, etc) to reduce the risk of accidents.
Make sure the switches on the control panel are in the "0" position (off ) and the machine is turned off. Keep away from naked flames,
do not short circuit the battery poles, do not cause sparks and do not smoke. Proceed as follows:
•
Disconnect the battery wiring and bridge terminals from the battery poles.
•
If necessary, remove the devices fixing the battery to the base of the machine.
•
Lift the batteries from the compartment using suitable lifting equipment.
The Battery-Charger
Never let the batteries run down excessively, as they could become damaged irreparably. Before recharging the batteries, ensure that you
have pressed the emergency button.
Choosing The Battery-Charger
Check that the battery-charger is compatible with the batteries to be charged:
•
Lead-Acid Batteries: an automatic battery-charger 24V - 20A is suggested. Anyway, refer to the manufacturer and read the
relative manual to confirm your choice;
•
Gel batteries: use a battery-charger specifically intended for this type of storage batteries.
Preparing The Battery-Charger
If you wish to use a battery-charger not supplied with the machine, it is necessary to mount on it the connector delivered with the
machine (see paragraph "Unpacking" of this manual). To install the connector proceed as follows:
•
Remove about 13 mm of sheath from the black and red cables of the battery-charger;
•
Insert the cables in the connector pins and push strongly with suitable pliers;
•
Insert the cables in the connector respecting the polarity (red cable +, black cable –).
Lifting And Handling The Machine
All stages must be performed in an adequately lighted environment adopting all necessary safety measures. Always wear individual
protections for the user's safety.
The loading of the machine onto a vehicle must be done as follows:
•
Empty the recovery tank and the solution tank;
•
Remove the squeegee and the brushes (or drive discs);
•
Remove the batteries;
•
Place the machine on the pallet, engage the parking brake and secure it with plastic straps or metal brackets;
•
Lift the pallet by means of a fork lift truck and load it on the vehicle;
•
Anchor the machine to the vehicle with ropes connected to the pallet and to the chassis of the machine.
9
Publicité
Table des Matières
