Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Flap adjustment
•
Loosen the screws (fig. 13, ref. 1);
•
Position the flap blade (fig. 13, ref. 2) so that it adheres perfectly to the floor;
•
Retighten the screws.
Detergents - Use
Always dilute detergents according to the supplier's instructions. Do not use sodium hypochlorite (bleaching solution) or other oxidizers,
especially if in high concentrations, and do not use solvents or hydrocarbons. The temperatures for water and detergent must not exceed
the maximum temperatures indicated in the technical data and must be free from sand and/or other impurities.
The machine has been designed to be used with non-foaming and biodegradable detergents specific for auto-scrubbers. Contact
the manufacturer to have a complete and updated list of the available detergents and chemical products; you will receive all papers
together with the Manual "Complete cleaning system". Use only products suitable for floors and for removing dirt. Follow the safety
rules concerning the use of detergents indicated in the paragraph "Safety regulations".
Setting Up The Machine
Before starting to work wear an apron, cap, non-slip waterproof shoes, a mask to protect the respiratory system, gloves and any other form
of protection indicated by the supplier of the detergent or necessary in the environment you are going to work in.
Before starting to work, perform the following operations:
•
Check the level of battery charge (recharge, if necessary);
•
Disengage the parking brake via the pedal (fig. 8, ref. 12);
•
Make sure that the recovery tank (fig. 2, ref. 2) is empty; if this is not so, empty it;
•
Check that the cock control lever (fig. 8, ref. 3) is at the position "off";
•
Fill the solution tank (fig. 2, ref. 3) through the respective hole on the front with clean water and non-foaming detergent in a
suitable concentration: leave a difference in level of at least 5 cm between the liquid surface and the tank opening;
•
Install brushes or drive discs suitable for the floor and the job to be done;
•
Lower the head by pressing the brush up-down button (fig. 8, ref. 5) on the arrow down;
•
Check that the squeegee (fig. 2, ref. 8) is fixed well and connected to the suction tube (fig. 9, ref. 4); make sure that the rear blade
is not worn.
If you use the machine for the first time, it is advisable that you train with it for a short time on a wide surface without any obstacles, to
acquire the necessary familiarity. Always empty the recovery tank before refilling the solution tank.
For an effective cleaning and long life of the equipment, it is necessary to follow some simple rules:
•
Prepare the work area, keeping away the possible obstacles;
•
Begin to work starting from the farthest spot, in order to avoid trampling on the area just-cleaned;
•
Choose paths that are as much straight as possible;
•
On wide floors divide the paths into rectangular and parallel areas.
At the end quickly mop the area, if necessary, to clean spots that are inaccessible to the scrubber.
Work
After setting up the machine, proceed as follows:
•
Insert and operate the key to release the main switch (fig. 8, ref. 2) and enable all the machine functions: the battery charge level
indicator will come on (fig. 8, ref. 9);
•
Move the cock lever (fig. 8, ref. 3) to the position of minimum flow of solution: the detergent solution begins to reach the
brushes;
12
Fig./Abb./ Рис 11
Fig. 13
Fig./Abb./ Рис 13
Fig./Abb./ Рис 15
Fig./Abb./ Рис 12
Fig./Abb./ Рис 14
Fig./Abb./ Рис 16
Publicité
Table des Matières
