Additional Functions - Dustbane Hurricane 700 XTT Manuel D'opération

Masquer les pouces Voir aussi pour Hurricane 700 XTT:

Mode d'emploi (56 pages)

Table des Matières

Les langues disponibles

•

Press the brush/roller up-down button (fig. 8, ref. 5) on the arrow down: the head will begin to move down and as soon as the

brushes touch the floor the brush motors will come on. As the brushes rotate, the solution is distributed over the floor;

•

Lower the squeegee by means of the proper lever (fig. 8, ref. 11): the suction motor comes on;

•

Press the drive lever (fig. 8, ref. 6) placed under the handgrip: the drive motor is started and the machine starts moving forward;

•

Adjust the running speed via the potentiometer (fig. 8, ref. 1);

•

If you wish to engage reverse gear during work with the squeegee lowered, you must first stop and raise the squeegee;

•

Check periodically that the detergent solution reaches the brushes/rollers and fill with solution if it runs out;

•

Check cleaning quality during work and adjust, as required, the flow of solution sent to the brushes/rollers (by rotating the

cursor (fig. 8, ref. 3)) and the pressure exerted by the head-brushes on the floor (via the brush up-down button (fig. 8, ref. 5) until

the test pressure indicator (fig. 8, ref. 8) indicates the required level).

In working conditions, if the emergency switch is accidentally pressed and the machine is switched off, when it is switched on again the

brush button must be pressed to re-activate the brushes. Never leave the machine stationary with the head lowered and the brushes in

motion: the floor could be damaged. Whenever you fill up the solution tank, always empty the recovery tank. Do not leave the machine

stationary with the suction motor on and the solution cock turned on.

•

If the warning led (fig. 8, ref. 9) starts flashing, it means that the storage batteries are getting flat. Therefore, it is necessary to

recharge them; if you keep on working, the batteries could become damaged irreparably;

•

If the suction unit revs up but does not perform suction, it means that the floater has cut in. In this case the recovery tank must

be emptied (see specific paragraph).

If for any reason the battery voltage drops considerably below the level envisaged, even temporarily, the drive lock may cut in. In this case

the machine must be switched off and then on again.

At the end of work:

•

Move the cock lever (fig. 8, ref. 3) to the position "CLOSED";

•

Release the drive lever (fig. 8, ref. 6) placed beneath the handle: the drive motor switches off and the machine stops;

•

Raise the head by pressing the brush up-down button (fig. 8, ref. 5) on the arrow up to stop the brushes (or drive discs or rollers)

and raise them to prevent them becoming permanently distorted;

•

Let the suction motor run for at least 2 minutes to make sure that it is completely dry;

•

By raising the lever (fig. 8, ref. 11), lift the squeegee from the ground to prevent continuous pressure causing distortion of the

drying blades and to switch off the suction motor;

•

Press the main switch (fig. 8, ref. 2) to disable all the machine functions;

•

Engage the parking brake via the pedal (fig. 8, ref. 12);

•

Empty and clean the recovery tank.

ис 11