Lifting And Transporting The Packaged Machine; Delivery Checks - Dustbane Labrador Serie Manuel D'opération

• All maintenance operations must be performed in an adequately lit place and only after disconnecting the machine
from the power supply, in cable models by unplugging the machine from the socket, in battery models by disconnecting
the battery connector; In cable models, the operator must also be able to verify from any position that the machine
remains unplugged from the mains socket while maintenance is being carried out.
• Only use original accessories and spare parts supplied by the Manufacturer to guarantee safe and problem-free operation
of the machine.
• Never use parts removed from other machines or from other kits.
The machine is designed and constructed to provide ten years' service from the date of manufacture shown on the nameplate.
After this period, whether the machine has been used or not, it should be disposed of according to current legislation in the
country in which it is used.
It should be disconnected from the power supply, emptied of all liquids and cleaned prior to disposal.
The machine is classified as WEEE-type special waste and is covered by the requirements of applicable environmental protection
regulations (2002/96/EC WEEE).
The machine must be disposed of separately from ordinary waste in compliance with current legislation and standards.
Also make sure that all parts of the machine that could represent a hazard, particularly to children, are made safe.
Alternatively, return the machine to the Manufacturer for a complete overhaul.
MOVEMENT AND INSTALLATION

Lifting and transporting the packaged machine

! WARNING: During all lifting operations, make sure the packaged machine is firmly secured to avoid it tipping up or being accidentally
dropped. Always load/unload lorries in adequately illuminated areas.
The machine is packaged on a wooden pallet by the Manufacturer. It must be loaded onto the transporting vehicle using suitable
equipment (see EC Directive 2006/42 and subsequent amendments and/or additions). At destination, it must be unloaded using
similar means.
A fork lift truck must always be used to lift the packaged body of the machine. Handle with care to avoid knocking or overturning
the machine.

Delivery checks

When the carrier delivers the machine, make sure the packaging and machine are both whole and undamaged. If the machine
is damaged, make sure the carrier is aware of the damage and before accepting the goods, reserve the right (in writing) to request
compensation for the damage.
Unpacking:
! WARNING: When unpacking the machine, the operator must be provided with the necessary personal protection devices (gloves,
goggles, etc.) to limit the risk of accident.
Proceed as follows to unpack the machine:
• Cut and remove the plastic straps using scissors or nippers.
• Remove the cardboard packaging.
Parts & Operations Manual
7
Labrador