Squeegee Adjustment; Brush Installation - Dustbane Labrador Serie Manuel D'opération

• insert the wires into the connector contacts and squeeze them forcefully with suitable pliers;
• respect the polarity (red wire + black wire -) when inserting the wires into the connector.
Squeegee installation and adjustment
Lower the squeegee using the lever (Fig. 3-ref. 1).
Lift the squeegee fastening levers (Fig. 3-ref. 3), insert the squeegee in the slots in the support (Fig. 3-ref. 2), then lower
the fastening levers (Fig. 3-ref. 3) and insert the suction hose (Fig. 3-ref. 4) in the squeegee.

Squeegee adjustment

The squeegee blades scrape the film of water and detergent from the floor
and prepare the way for perfect drying. With time, the constant rubbing
makes the edge of the blade in contact with the floor rounded and cracked,
reducing the drying efficiency and requiring it to be replaced. The state
of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that
the edge of the rear blade bends during operation by about 45° with respect
to the floor at every point. The angle of the blades can be adjusted using
the screw (Fig. 3-ref. 5), while the height of the squeegee from the floor can
be adjusted using the knobs (Fig. 4-ref. 6).

Brush installation

Automatic brush attachment, version without traction (Fig.21): raise the machine head by pushing
the head lift pedal down and to the left, then using the operation selector, select the Brush control, rest
the brush on the floor in front of the machine and centre it with the head. Lower the head by pushing
the head lift pedal down and to the right and activate the drive lever momentarily; the brush will be
attached automatically to the hub on the flange. If the operation is not successful, repeat by pressing
the lever again and repeating the centering. Use of abrasive/microfiber disks: fit the abrasive/microfiber
disk on the drive disk and perform the operations described for fitting the brush on the scrubber dryer.
Automatic brush attachment, version with traction (Fig.21): raise the machine head by pushing the
head lift pedal down and to the left, then using the operation selector, select the Brush control, rest
the brush on the floor in front of the machine and centre it with the head. Lower the head by pushing
the head lift pedal down and to the right, turn the selector to the "OFF" position, press the "SET" button
once then press the "+" button, the machine will complete the attachment sequence. Use of abrasive/
microfiber disks: fit the abrasive/microfiber disk on the drive disk and perform the operations described
for fitting the brush on the scrubber dryer.
Automatic brush attachment, version "XP": position the brush underneath the head, turn the selector
to the "OFF" position, press the "SET" button once then press the "+" button, the machine will complete
the brush attachment sequence.
Automatic brush release, version with and without traction (Fig.21): raise the machine head by
pushing the head lift pedal down and to the left, turn the selector to the "OFF" position, press the "SET"
button once then press the "-" button, the machine will complete the release sequence.
Automatic brush release, version "XP": turn the selector to the "OFF" position, press the "SET" button once then press the "-"
button, the machine will complete the release sequence.
Attaching the brush roller (Fig. 23): raise the machine head by pushing the head lift pedal down and then to the left, fit the rollers
in their housing by first inserting them on the drive pulley, then pushing them upwards until they click into place.
10
Parts & Operations Manual Labrador