Dustbane Labrador Serie Manuel D'opération page 15

Emptying the collection tank
If the tank is full, the display shows the corresponding alarm, see the chapter "Display
alarms"; after a few seconds, the suction motor shuts down, then stop the machine
and empty the tank following the instructions shown below. To resume work, turn
the operation selector to the OFF position (reset errors):
• Switch off all the machine's functions.
• Take the machine to the disposal area.
• Unhook the hose from the clip.
• Empty the tank using the hose (Fig. 12, ref. 1), at the end rinse the tank
with clean water.
Emptying the water/detergent tank
To empty the tank, follow the instructions shown below:
• Switch off all the machine's functions.
• Take the machine to the disposal area.
• Stop the machine.
• Empty the tank by unscrewing the filter assembly (Fig. 13-ref. 1).
Emptying the roller (cylindrical only)
• Remove the sweeper collection bin (Fig. 24), dispose of the contents and rinse out the bin with clean water.
Filling the water/detergent tank
Fill the tank through the opening provided (Fig. 14, Ref. 1). The machine is equipped with a graduated measuring cap that can
be used to dilute the detergent inside the tank. If the tank is empty, the display shows the corresponding alarm, see the chapter
"Display alarms"; to resume work, turn the operation selector to the OFF position (reset errors).
Filling the Chem-Dose tank (accessory)
Open the dirty water tank lid, fill the container highlighted in the drawing (Fig. 14-ref. 2) with detergent.
Finishing work
! INFORMATION: Empty the dirty water tank and recharge the batteries
After having finished work, remove the electronic key.
Moving the machine when not in operation
Proceed as follows to move the machine:
• Raise the squeegee.
• Raise the head.
• Move the operating program selector to Off.
• Versions with mechanical drive: push or pull.
• Version with electric drive: activate the drive lever.
Parts & Operations Manual
15
Labrador