Squeegee Adjustment; Moving The Machine When Not In Operation - Dustbane Hurricane 400 Manuel D'opération

Squeegee adjustment

To mount the squeegee on the machine, proceed as follows:
• Check that the squeegee mount (ref. 2) is raised, otherwise lift it by means of the squeegee lever (ref. 5);
• Insert the suction hose sleeve (ref. 4) fully into the squeegee;
• Slacken the two knobs (ref. 3) at the centre of the squeegee;
• Insert the two threaded pins into the slots on the support (ref. 2);
• Fix the squeegee by tightening the two knobs (ref. 3).
The squeegee blades scrape the film of water and detergent from the floor and prepare the way for perfect drying. With time, the
constant rubbing makes the edge of the blade in contact with the floor rounded and cracked, reducing the drying efficiency and
requiring it to be replaced. The state of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during operation by about
45° with respect to the floor at every point. Adjust the angle of the blade during operation by regulating the height of the two
wheels positioned behind the squeegee (ref. 1).x).

Moving the machine when not in operation

Proceed as follows to move the machine:
Fig./Abb./
• Raise the squeegee.
• Raise the head.
• Move the machine as follows:
Non-Traction units: push or pull;
Traction units: to move the machine forwards, press the button/selector and then operate the drive lever. To move the machine
backwards, press the button/selector again then operate the drive lever. Speed can be varied by the potentiometer knob.
Once you have reached your destination, lower the head by pressing the release pedal down and to the left, then release it.
Fig./Abb./
10
Operations Manual
Fig./Abb./
图
9
图
1 2
10
图
Hurricane 400 XTT / Hurricane 400 XTT – Traction
7
Fig./Abb./
3
4
5
Fig./Abb./
8
图
11
图