Detergent Filter: Cleaning; Squeegee Blades: Replacing - Dustbane Hurricane 400 Manuel D'opération

Detergent filter: cleaning

Fig./Abb./ 9
图
1 2
Fig./Abb./ 10
• Unscrew the screw located below the bottom tank (ref. 1);
图
• Unscrew the detergent filter (ref. 2);
• Clean the filter with running water or the detergent solution used on the machine;
• Replace the filter back in its housing, making sure it is correctly positioned and retighten the screw.

Squeegee blades: replacing

The squeegee blades collect the film of water and detergent from the floor and prepare the way for perfect drying. With time, the
constant rubbing leaves the edge of the blade in contact with the floor rounded and cracked, reducing the drying efficiency and
requiring it to be replaced.
Turning or replacing the squeegee blades:
• Lower the squeegee by using the squeegee lever;
• Remove the squeegee from its mount by completely unscrewing the two knobs;
• Remove the suction hose sleeve from the squeegee;
• Release the catch (ref. 3 or 6);
• Remove the two blade retainers (ref. 2 or 7) by first pushing them towards the body of the squeegee (ref. 1) then
extracting them;
• Remove the blade (ref. 4 or 5);
• Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out,
or replace with a new blade, fitting it onto the screws on the body of the squeegee (ref. 1);
• Reposition the two blade retainers (ref. 2 or 7) by centering the widest part of the slots over the fixing screws on the
squeegee body (ref. 1), then pushing the blade retainers inwards;
• Refasten the catch (ref. 3 or 6).
• Replace the squeegee in its support
Fig./Abb./ 8
图
3
4
5
Fig./Abb./ 11
图
Fig./Abb./ 12
图
Fig./Abb./ 13 Fig./Abb./
图
Operations Manual
A
14
图
Hurricane 400 XTT / Hurricane 400 XTT – Traction
15