Finishing Work - Dustbane Hurricane 400 Manuel D'opération

Working
After setting up the machine, proceed as follows:
• Connect the machine as follows:
• Move the tap lever to the minimum detergent flow position. The detergent solution starts flowing to the brush;
• Lower the squeegee by means of the corresponding lever;
• Press the brush switch;
• Press the suction switch to start the suction motor;
• Press the brush/drive lever;
Non-Traction units:
• When the brush switch is in the "1" position and the drive lever is pulled, the motor which turns the brush and moves the
machine starts up. A special mechanical drive device uses the friction between the brush and floor to generate a forward
movement. When the mechanical drive lever is released, the brush motor shuts down and the machine stops.
If the machine pulls to one side, restore a straight course by using the direction regulation knob. If the machine pulls to
the right, turn the knob clockwise and vice versa.

Finishing Work

• Place the tap lever in the "CLOSED" position;
• Release the brush/drive lever located under the handgrip. This turns the brush/drive motor off and the machine stops;
• Stop the brush / pad;
• Lift the lever to raise the squeegee from the floor to prevent the continuous pressure from warping the blades;
• Let the suction motor run for at least 2 minutes to make sure it is completely dry, then press "0"
on the suction switch to switch off the suction motor;
• Remove the brushes (or drive pads) to prevent them from warping permanently;
• Press the button to turn the optional CHEM DOSE accessory off;
• Depending on the model, disconnect the ANDERSON connectors;
• Empty and clean the dirty recovery tank.
Some useful tips to get the most from your scrubber dryer
In the event of particularly stubborn dirt on the floor, washing and drying can be performed in two separate operations.
Pre-washing with brushes or pads:
• Select the Brush operating program.
• Activate the drive lever, start working.
• If necessary, adjust the flow of detergent delivered to the brush; the outlet flow must be metered in relation to the
required travel speed; the slower
the machine travels, the less detergent must be delivered.
• Persist when washing particularly dirty points to give the detergent time
to perform its chemical action detaching
and suspending the dirt and the brushes time to exert an effective mechanical action.
Drying
• Select the Suction operating program, lower the squeegee.
• Activate the drive lever, start working.
• Pass over the same area washed previously. The result is equivalent to
in-depth washing and subsequent ordinary maintenance will take less time.
12
Operations Manual Hurricane 400 XTT / Hurricane 400 XTT – Traction