Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Brush/drive disk release:
Turn the machine on by pressing the main switch (3) (LED on), then press the brush button (4)
(LED on). Raise the front of the machine by levering on the handle, then operate the brush lever
(fig. D, ref. 1) repeatedly. After a few pulses, the brush (or drive disk) is released and falls to the
ground.
Detergents – Instructions
IMPORTANT: Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlorite (bleach) or other
oxidants, particularly in strong concentrations. Do not use solvents or hydrocarbons. The temperature of the water and detergent must not
exceed the maximum indicated in the technical specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made specifically for scrubber driers. For a complete
and up-to-date list of the detergents and chemicals available, contact Dustbane. Use products suitable for the floor and dirt to be
removed only. Follow the safety regulations on use of detergents given in the section "Safety Regulations".
Preparing The Machine For Work
IMPORTANT: Before starting work, wear overalls, ear protectors, non-slip waterproof shoes, mask to protect the respiratory tract, gloves and
all other personal protection devices recommended by the supplier of the detergent used or necessitated by the work environment.
Before starting work, proceed as follows:
•
Check the battery charge (charge if necessary);
•
Make sure the dirty water tank (2) is empty. If necessary, empty it;
•
Via the opening at the front, fill the detergent tank (8) with a suitable concentration of clean water and low-foam
detergent. Leave at least 5 cm between the surface of the liquid and the opening of the tank;
•
Mount the most suitable brushes or drive disks for the floor and work to be performed (see paragraph 3.4);
•
Make sure that the squeegee (5) is securely fastened and connected to the suction hose;
•
Check that the rear blade is not worn (standard version with brushes and drive disks).
INFORMATION - If you are using the machine for the first time, we recommend trying it on a large obstacle-free surface first to acquire the
necessary familiarity. Always empty the dirty water tank before filling the detergent tank again.
For effective cleaning and to extend the working life of the machine, follow a few simple rules:
•
Prepare the work area by removing all possible obstacles;
•
Begin working from the furthermost point to avoid walking on the area you have just cleaned;
•
Choose the straightest possible working routes;
•
Divide large floors into parallel rectangular sections.
If necessary, finish off by passing a mop or rag rapidly over parts inaccessible to the scrubber drier.
9
Publicité
Table des Matières
