Fuses: Replacing; Regular Maintenance; Daily Operations; Weekly Operations - Dustbane Hurricane 890 XTT Manuel D'opération

in contact with the floor rounded and cracked, reducing the drying efficiency and requiring
it to be replaced.
Turning or replacing the blades:
• remove the squeegee (fig. B ref. 6) from its support (fig. E ref. 3) by completely
unscrewing the two knobs (fig. E ref. 2)
• remove the sleeve of the suction hose (fig. E, ref. 1) from the squeegee;
• release the clip or unscrew the bolt (fig. I ref. 3 or 6);
• remove the two blade retainers (fig. I ref. 2 or 7) by first pushing them towards the
body of the squeegee (fig. I ref. 1) then extracting them;
• remove the blade (fig. I ref. 4 or 5);
• reuse the same blade by reversing the edge in contact with the floor until all four edges
are worn out, or replace with a new blade, fitting it onto the screws on the body of the
squeegee (fig. I ref. 1);
• reposition the two blade retainers (fig. I ref. 2 or 7) by centring the widest part of the
slots over the fixing screws on the squeegee body (fig. I ref. 1), then pushing the blade
retainers inwards;
• fix the clip or screw up the bolt (fig. I ref. 3 or 6);
Replace the squeegee in its support following the instructions in paragraph 6.2.

9.2.4 Fuses: replacing

• turn the main switch (fig. A, ref. 1) to the "0" position.
• remove the cover of the electrical compartment (fig. L)
• check the fuses (fig. L ref. 1)
• replace with a new fuse.
• close the cover
Fuse table: For the complete fuse table, see the spare parts catalogue.
Never use a fuse with a higher amperage than specified.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be
identified and repaired. Have the machine checked by qualified personnel.
9.3.

Regular maintenance

9.3.1. Daily operations

• After each day's work, proceed as follows:
• empty the collection tank and clean if necessary;
• clean the squeegee blades and check for wear. If necessary, replace.
• check that the suction hole in the squeegee is not blocked. If necessary remove
encrusted dirt;
• recharge the batteries according to the procedure described.
• Models with roller brushes: empty the debris bin (fig. O, ref. 5) by extracting it
sideways. Empty the debris and wash.

9.3.2. Weekly operations

• Clean the collection tank float and make sure it is working correctly;
• clean the suction air filter and make sure it is undamaged. If necessary, replace.
• clean the suction hose;
• clean the collection and solution tanks;
    IMPORTANT
ENGLISH
21
21