Warnings And Fault Indicators; Rear Side; 1Tower Units - Chloride Power Protection ACTIVE Manuel Utilisateur

Chloride Active
4.2.2.2 Warning and fault indicators
UK
Display Message
BATTERY FAULT
INVERTER OVERLOAD
BYPASS OVERLOAD
CHARGER OVERVOLTAGE
DC BUS OVERVOLTAGE
DC BUS UNDERVOLTAGE
DC BUS UNBALANCE
INVERTER OVERVOLTAGE
INVERTER UNDERVOLTAGE
INVERTER SHORT
SITE WIR. FAULT
The LCD Display shows the last fi ve events stored and the runtime when they happened (menu 4). They
are listed from 1 to 5, being 1 the newest event and 5 the oldest event. Event 1 is the fi rst one to be
displayed and events from 2 to 5 are displayed sequentially by pressing the Scroll-Down button.

4.3 Rear Side

4.3.1 Tower units
Active 700 T:
24
945044.066
UPS stopped because RPO (Remote Power Off) has been activated
RPO ACTIVE
Overload detected on the inverter (line mode or battery mode)
FAN FAULT
Site wiring fault detected. Please check input wiring arrangement.
Description
Battery failure has been detected. Please check batteries.
Overload detected when the unit is on bypass mode
Fan failure has been detected
Charger is delivering overvoltage (internal failure)
DC voltage on the DC bus too high (internal failure)
DC voltage on the DC bus too low (internal failure)
DC voltage on the DC bus unbalanced (internal failure)
Inverter is delivering overvoltage (internal failure)
Inverter is delivering undervoltage (internal failure)
Short-circuit on the inverter (internal failure)
1. SNMP Slot
2. Input circuit breaker
3. Input power connection
4. Not controllable output sockets
5. Controllable outlets (2 groups)
6. USB port
7. RS232 port
8. Fan
9. ROO/RPO terminals
10. Earth screw