Chloride Power Protection ACTIVE Manuel Utilisateur page 16

Chloride Active
Please use only the supplied fasteners to attach the supplied mounting brackets to the UPS or external
UK
battery packs.
If external battery packs are included in your installation, please mount them Þ rst and as low as possible.
Start with the lowest available position and work up. Your UPS should be installed last and end up on the
top of all the battery units for proper cable routing.
ATTENTION: Use all supplied mounting hardware on each UPS and external battery pack. NEVER depend
on lower devices to support other devices.
All mounting materials are available (bundled or optionally) to install the UPS into a rack. To prepare the
UPS and external batteries for use in a rack conÞ guration, Þ optional accessory),
and then install the UPS and batteries following the steps below:
1. Attach rear of rails to rear of rack with two screws provided
14
945044.066