Front Panel Indicators And Operating Elements Description; 1Units With Led Indicators; Description Of The Elements - Chloride Power Protection ACTIVE Manuel Utilisateur

Chloride Active

4.2 Front Panel Indicators and Operating Elements Description

UK
4.2.1 Units with LED indicators
Depending on your local market, the UPS can be equipped with a front panel containing a series of
switches and indicator LED's that provide the operator with the current status of the UPS and the ability to
change UPS operational mode.
NOTE: for units with front panels with LED indicators, front panels with LCD display are available as an
accessory and have to be ordered separately. For operation details about them please refer to section 4.2.2

4.2.1.1 Description of the elements

The front panel contains a series of switches and indicator LEDs that provide the operator with the current
status of the UPS and the ability to change UPS operational mode:
- Inverter ON/OFF switch and LED
- A simplifi ed block diagram of the UPS shows the current operational mode of the UPS (i.e. line mode,
battery mode, bypass mode)
- Two LED indicators show the current status (ON or OFF) of the controllable outlets 1 and 2.
- Four additional LEDs provide error status, UPS load percentage or battery charge percentage depending
on the associated front panel button status.
- Site Wiring Fault detection switch and LED
18
945044.066
1. Site Wiring Fault Detection LED
2. Battery Fault LED
3. UPS Fault LED
4. UPS Overload LED
5. Display Selection Button
6. LED Test/Alarm Reset Button
7. Site Wiring Fault E/D Button
8. Site Wiring Fault E/D LED
9. Outlet 1 ON/OFF LED
10. Outlet 2 ON/OFF LED
11. Bypass Mode LED
12. Line Mode LED
13. Battery Mode LED
14. Inverter ON/OFF Button
15. Inverter ON LED