Indicators; Led Display - Chloride Power Protection ACTIVE Manuel Utilisateur

Chloride Active

4.2.1.3 Indicators

UK
The following chart describes visual and acoustic indications when certain conditions happen. For visual
indications, only the representative LEDs are shown (the others may be ON or OFF, depending on other
operative conditions).
20
945044.066

LED display

Indicators Acoustic
All LEDs fl ashing
Three beeps
three times
LED 4 fl ashing. Continuous
LEDs 1, 2 & 3 off beep
LED 4 fl ashing. Continuous
LEDs 1, 2 & 3 off beep
Depending on
LED 3 fl ashing.
LEDs 1, 2 & 4 off
LED 13 fl ashing
Three beeps
three times
LED 4 ON
LED 3 ON
LED 2 ON
LED 1 ON
LED 1 OFF Continuous
LED 2 OFF beep
LED 3 OFF
LED 4 OFF
LED 4 ON
LED 4 fl ashing. One beep per
LEDs 1, 2 & 3 off second
LED 2 fl ashing.
One beep per
LEDs 1, 3 & 4 off
second
LED 3 fl ashing. One beep per
LEDs 1, 2 & 4 off second
One beep
LED 1 ON, LED
every three
13 fl ashing
seconds
LED 2 fl ashing. One beep
LEDs 1, 3 & 4 off every 30
minutes
LED 8 ON
LED 1 fl ashing,
Continuous
LEDs 2, 3 & 4
beep
OFF. LED 8 ON
UPS Condition
Start-up
sequence
Overload fault
Inverter
shortcircuit fault
fault
Other UPS fault
Line Mode to
Battery Mode
Remote Power
Off warning
Overload
warning
Battery
disconnected or
battery test fault
Charger fault
Battery Low
LCM Alarm (end
of battery life)
Site Wiring
Fault detection
-
enabled
Site Wiring Fault
Detected